Recent content by stevec

OK. I'll give that a shot this weekend. I assume I should also take apart the shower heads and make sure they are clean. Thanks, Steve

I seem to have terrible water pressure on the boat in general when I use either shore water or my tanks. Is there a inline filter that I'm missing some place? Thanks, Steve

Thanks for the reply. I've had some issues and this is the first I've been able to get back to the forum. I replaced the pump and switch with and it works fine now. I have one tank where the two showers, three sinks and two AC condensations come in to.

This past weekend I experienced an issue with my shower/sink sump tank pump. It was making some noise, but was not pumping any gray water out. I'm not sure if it was clogged (pretty disgusting down there!) or if it needs to be replaced. I cleaned the tank out as best as I could, but had to...

Thanks! That's a great idea...it would be nice to have the a build sheet on file. -Steve

That's a good idea! How did you attach the brakcets? Do you just use the normal house filters from Home Depot? -Steve

Thanks...I have that manual. That's the first place I looked, but it does not tell me the model number or brand of the AC unit. It looks like I am going to have to wait until I can get down to the boat this weekend to get that information and/or measure the size of the filter I need.

Thanks, Mike...will do. Have to wait until this weekend, though. Do you have a certain place you buy from?

Those look great! No I have to figure out what model(s) I have on the boat. :-)

The toggle switch on my panel monitor seems to be flakey. When the panel get's wet, the panel alarms. If I play around with the switch (hold it in the down position) the alarm turns off. I new panel monitor is about $225. I would like to get buy with just replacing the switch. Does anyone...

Both my AC units need new filters. The previous owner duct tapes some filters to the units and I want to get the OEM filters. Does anyone know what the part number would be and where I can purchase them? Thanks, Steve

Wow! Thanks for the reply. I thought I might be able to do it myself, but it sounds like one heck of a job. You don't happen to remember what the part number for the impeller was, do you? I think its 034440. Thanks again, Steve

I have a 1997 sedan bridge with a Westerbeke 8.0 KW generator with the serial number 106333D609/9525603. The sticker on the generator is pretty worn, so I can't locate the model number. It looks like I need a new impeller for the generator, so I have two questions: 1. Can someone help me...

Thanks. According to my Sea Ray parts dealer, it's a Southco. I just can't match up the part number on any of the site.s

Thanks! I didn't even think about that option.