Recent content by roger2015

is this just a simple swap and go with bleeding the air as I am assuming? thanks for any replies.

ok I know I have read this issue on here somewhere, ad I cant seem to find it but I need to replace my tank on my tilt trim pump. I haven't been out in a while and noticed it leaking,so my question is it just a swap an go, as I know there has to be certain pressure for the up an down, both being...

I guess to me its like having that extra vehicle in the drive way that is barely used for whatever reason, do you not start it to keep it up in mechanical condition to lubricate the seals charge the battery, keep the fuel from getting stale in the lines and removing any condensation, as others...

I feel your pain when putting the fenders out.....my question to you since I have an 88 Sorrento that only have the forward and afy cleat, I would like alittle more versatility, where are you installing these if I may ask,

I heard that the life jacket wasn't COAT GAURD APPROVED

I tube often and I make sure that my riders know the hand signals on the tube, you know thumbs up for more speed tumb down for less speed right arm over head is done riding, both arms bent over head is everything is OK, of course you can make up your own and purchase a flag to display when rider...

looked up he answer to the question I asked:smt024 happy boating

welcome to CSR, a lot of good people and info here....nice ole boat you got there..

cliff I would have to agree here, last year I started looking for a boat after many months I found her....my Searay, as in 28 yr old Searay that is in immaculate condition I may add, a few mechanical things to fix but that's it and in far better shape than boats 10-15 yrs newer....... and I...

one side is male and the other is a and the other side is female bullet type connector

does it matter which one of the wires goes to the blue block from the trim sender, the connectors are bullet type from factory on the trim sender and the connection from the old sender on the mercathode have eyelets connectors, I was going to splice using waterproof connectors to make it...

Thanks Bt Doctur, show the system I have Appreciatecthe help

Yep that shows how mine is....appreciate it very much Sent from my iPhone using Tapatalk

There also a Solenoid on the back side of mercathode Sent from my iPhone using Tapatalk

Ok so where does the trim sender wire go, can't find the over end like the trim limit side Sent from my iPhone using Tapatalk