Recent content by phil_p

Sorry, both gone.

Hi all. Just replaced the windshield vent gaskets with approx 1' on each side & 2' alone the bottom, with the Taylor Made gasket 835200 - picture attached. I'd ordered 5' of the gasket @ $8/LF plus shipping and handling but for some reason they sent me a lot more, probably enough for 2 boats at...

Thanks Gene. I'll check it out. Have you ever taken the framing apart and replaced the screen/?

Hi folks. I've been out of pocket for awhile. Question: Has anyone replaced the sliding screens on the 4 overhead hatches on a 1999 370? Some guidance on how to remove the frame and where to get replacement screens would be most appreciated. Or is there a recommenced cleaning solvent that might...

Hi all, Hope anyone effected by the hurricanes is well and didn't suffer any damage. I'm just getting back to the forum after being out of the country for over a month and came back just before Irma came visiting here in Clearwater. Where it bad it could have been much, much worse. My sympathies...

Fly'n, Sounds like your GFCI breaker outlet is tripped as one possbility. On my 1999 370 there's a "GFCI" outlet (http://home.howstuffworks.com/question117.htm) in the head located on the left, underneath the medicine cabinet. There's a button that need to be pressed in to reset and a green...

Honors due. That looks fantastic.

Thanks Gene, Dancer, et al. Sure enough. found the GF switch in the head outlet under the medicine cabinet. Wasn't blown, just tripped for some reason, maybe storms. That was the same one that was completely shorted out when I first bought the boat but I didn't remember or couldn't easily see...

Could use some immediate help guys & gals. All of my 110V outlets have ceased to work suddenly from one day to the next. It was working fine the day before when I was charging a battery and yesterday when my mechanic changing out the manifolds had a fan going. Came on the boat today and needed...

Scott, Thanks for the comment and possible problem area. I've had this 370 since June 09 and this is the first time I recall having the problem. But it's also the fist time it's sat for a week after a full filling without burning off some gas and the first time I've used this or any stabilizer...

Hey Folks. Anyone ever had an issue with a lingering gasoline smell. A few weeks ago I topped off my tanks, approx. 75 gal each P & S, and for the 1st time added some West Marine stabilizer. Several days later we were on the boat doing this & that and there was a distinct gas smell in the cabin...

Gene, Thanks. I've been in touch with the guts at Flounder. Panel do look nice but they're an arm and a foot. May have to bite the bullet. Not a good time since I just did a bottom job, repaired the hydraulic swim platform and the forward A/C unit has decided to make my life miserable by...

Noodles37, My gage panels are all faded and/or falling apart. I'd be interested to know what material you used for the panels, what you did for the lettering, etc. A picture would be appreciated. They're pricey from Founder Pounder and there was a gut on this thread a few years back that did a...

Agree, mine is like a rock. I've been thinking of just putting a 2 or 3" Novafoam or similar type mattress pad over it, cut to size. Easy and inexpensive solution but you're adding height to an already high platform.

Chip & Gene, Thanks for the comments and advice. Sorry for the delayed responding; weddings and holidays seem to come at the same time. I got down and cleaned out the shower sump which also takes the condensate from both the forward and and midship A/C units. There appeared to be at least 10...