Recent content by Duke27ca

Port side is only getting up to 2800RPM, starboard side 2400RPM. I usually do have to use the tabs to get on plane, only running T 5.7's. I will have the carbs checked out.

Sure is, I will have this checked out

yes, I do have the other fuel filters as well. The small filters at the carbs were replaced.

Yes it does have fuel filters on the bulkhead, I bypassed them to test, that is when my boat got up on plane recently, but when I returned back out, wouldn't get up again, still with these being bypassed.

I will try changing the filters once again, I suppose there could be dirt in the tank. Is there anything you can put in the tank to help clean it, even with fuel in the tanks? I currently have about 300 litres of fuel in each tank (about 80 gallons)

There wasn't any water in it at all.

The gas is new in the past week or so, approximately 200 new litres in each tank.

Hi thanks, it was just scrubbed 2 weeks ago.

Hi, I have a 1990 310 Sundancer with twin 350 V-drives and this year can not get on plane. The port engines on load full throttle is getting 2800 RPM's, the Starboard is getting 2400 RPM's. The other day I changed out the fuel filters and the little ones at the carburetors, ran great, 4000...

Looking to upgrade my electronics in my 1990 310 Sundancer and am looking for suggestions. Here is my current set up. • Raytheon R20XX Radar, 24NM, c/w Ritchie Fluxgate dedicated compass • Raytheon V850 Colour Depth Sounder c/w colour Chart Card facility • Raytheon RAYStar 125 GPS antenna...

Wanted Extended swim platform for 1990 310 Sea Ray Sundancer

I will take the swim platform. Where can I pick it up?

If you think it would fit my 1990 310 Dancer I will take it. Let me know, does it come with any mounting hardware?

Do you know how it would fit on a 1990 310 Sundancer? The picture of the boat above is with the platform that is for sale, correct? I'm in Ontario.

Wanted Canvas top for 1990 310 Sundancer