My question is how do you get to the area where the boat sits on a trailers bunk boards? I need to wax my boat and I'm not sure how long it has been since it was waxed in this area. I've owned the boat for 2 years now and never waxed this area.
I've got a '98 190 BR Signature. It has the 4.3L (260 CID). The 4th time I took it out it started knocking. So I rebuilt it myself. It was cheaper then finding a used engine. You never know what you got when buy used. A new engine will be well over a grand. My engine had its rings seized on...
I've got a '98 190BR w/ 4.3L/A1. It came with a 21p HyFive 5 blade. It's got a heck of a hole shot but only tops out at 43knots at 5000 rpm. This is with a full tank, 200-250lbs of gear, 3-4 people.
IF it's knocking in neutral then it's not the lower drive. Neutral is like park/neutral in your car. If it's making a knocking noise in park/neutral and not in gear then its the engine or the coupling to the upper unit; ie. the output shaft. In this case I would say it's rings or bearings. Does...
No. I still have the other problem with the engine sounder not working. The wires are connected correctly. I think I burnt out the piezo. They aren't meant to sound for long periods of time. Mine sounded for a good 30 mintues then faded out.
The Transducer is mounted low by the starboard side of the transom. The wiring goes thru the hull higher up but still next to the transom. I have a pic of my dash in my album. http://clubsearay.com/forum/album.php?albumid=71&pictureid=429. The shape of the emblem is more like a black T on a...
If it's original who made it and what model? I have seen this very model on other 190's listed on the internet but nobody can tell me who made it or a model #.
Can anyone tell me if the camshafts are the same or different between a 1998 2 barrel 4.3L mercruiser and the 1998 4 barrel 4.3L mercruiser? Lift/Duration/Lobe Seperation?
I've got a '98 190 BR w/4.3L Mercruiser. I have just recently rebuilt the engine. When I started the engine to break it in there was an alarm that sounded. It was buzzing as soon as I turned the ignition key on. Once the engine started it normally would shut off. It did not at this time. After...
I was wondering if my boat has enough power to pull two skiers at once. It is a '98 190 Bowrider w/4.3L(freshly rebuilt) Bravo 1 Gen Plus and a 5 blade SS prop. It jumps out of the water and onto plane very quickly. It as a top speed of 42mph with the 5 blade. I do a stock 3 blade for it but...
Just recently I have had to rebuild my 1998 Mercruiser 4.3L. check out the discussion: http://www.clubsearay.com/forum/showthread.php?t=12558
The only difference in it and a vehicle engine was the thickness of the rings. The vehicle rings are standard size the marine rings are metric. As in my...