I feel you. I went with OEM, cost a fortune. Even with that, both engines are behaving the exact same. No codes on smart craft gauges or on the scan tool. Also on my scan tool, it says guardian mode not defined, but I was reading about the knock sensors possibly being responsible to retarding...
Starboard engine are new injectors, port just had them sent out for cleaning and got a report back that they are all metering the correct flow and spray pattern. throttle body blade is wide open and scan tool reads them respectively port as 99.2% and Stbd at 99% at WOT. If there was not enough...
I have read the Merc service bulletin that describes how to build a test light, set the engine to TDC #1 and then rotate to 16°btdc, unplug the cam sensor cable on the dist and plug in the test light and adjust until the light goes out. Did that, did not seem to make a difference. Engines seem...
Just pulled plug on both motors last night, they look very good. Brand new Gen III cool pump on starboard motor, original on port motor. Filters are clean and new.
Hello out there, I have a 2006 Searay 320, just did a repower of the starboard motor about 6 months ago and thought everything was great. Original port motor (strong as an Oxx) would turn 4500 RPM WOT, new starboard motor would turn 4200 WOT. Did not think much of this since I now had two good...
Thanks, guys, for the input. I will look into tying in SOG from my GPS, but the paddle wheel is connected to the CAN NETWORK on my starboard engine. I am not sure the Smartcraft speedometer will accept boat speed from GPS. The two choices in the meter configuration are PITO or PADDLE. The...
Hello All,
I have an 06' Sundancer 320DA and have three smartcraft gauges, one Tach for each engine and one Speedometer in the middle. The system is set for boat speed to come from the paddlewheel and all three gauges read boat speed but here is the catch, after running for a few seconds at...
Hello All,
I have an 06' Sundancer 320DA and have three smartcraft gauges, one Tach for each engine and one Speedometer in the middle. The system is set for boat speed to come from the paddlewheel and all three gauges read boat speed but here is the catch, after running for a few seconds at...
I have a 06' 320 with a pair of 350 MAG MPI inboard v-drives. I have not had much time to sort through the stbd engine harness but I am looking for the where the connection is for the starboard smartcraft fuel level sensor. I had some engine work done and now have suddenly lost fuel level on my...
Hey there, just pulled my starboard engine out of the boat to replace the block. Got new block and everything swapped over from original block and got it fired up in my drive way, but the issue I am having is with fuel pressure. When I first started the new engine up, it started straight away...