Recent content by Atis

  1. Atis

    Need specs on 1987 SR Sundancer

    Found the little 2 page brochure....now if I could find the owners manual! Thanks, didn't realize they listed it as DA. I searched the prop to death when I had her trailer. Nothing anywhere. Even had my father in law check it incase I was having a case of stupids.
  2. Atis

    Need specs on 1987 SR Sundancer

    That was gps speed...before I put the boat in the water I checked the prop and it was not marked. My biggest issue right now if the crap growing on the bottom. I bet I have 150lbs of barnicals. I trim watching the rpms and gps speed...looking for the spot were i get lower rpms and more speed...
  3. Atis

    Need specs on 1987 SR Sundancer

    Sorry, forgot to say I think I paid $170 for the sensor. Its great, instant reading on what the engine is drinking, plus tells you how much fuel is left.
  4. Atis

    Need specs on 1987 SR Sundancer

    thanks, i guessed 40g when I set the fuel flow up...juat to be safe. I got it from WM, ties into the garmin via the nea.system. Took longer to the pull the cord from engone bay then it did to install the flow sensor. I added a fusion radio that I tied into the garmin as well so I have full...
  5. Atis

    Need specs on 1987 SR Sundancer

    Well today I realized my boat is not a Weekender but a Sundancer due to having an aft "cabin"... IE Batcave. I have spent the summer doing some upgrades and add the Garmin Fuel usage sensor...now the fun part... whats the gallons on a stock tank? I cant find a manual or anything else that...
  6. Atis

    Newbie just bought a boat! Help!

    Congrats Nick on the find!
  7. Atis

    prop/rpm/mph on a da250

    that would be nice. i had to use tabs to get on plane and then brought them up a little amd did a little motor trim to stay level amd drop rpms. I know the book calls for a 15.25 x 15 prop but dang...try and find one. I would even settle for a 15x16.
  8. Atis

    prop/rpm/mph on a da250

    sadly, no prop shop nesr me....mostly sail boats and a ton of bass boats but there is a good overall boat repair shop I will stop in and talk to. thanks for the tip on the tach. I will try and get to thr back of her and check.
  9. Atis

    prop/rpm/mph on a da250

    trim tabs work. i juat replaced the HPU and tested them before going into the water. motor trim works as well. i keep focusing on the prop because the guy had 4 boats...so if he damaged the prop he probably would have grabbed an old one from another boat. Its SS so I know its not original as I...
  10. Atis

    prop/rpm/mph on a da250

    I tried to confirm prop when I had her on trailer but couldnt locate numbers. I didnt run her across the scales so weight is unknown. MPH was based off the Garmin GPS so it should be accurate. How do I confirm my outdrive ratio?
  11. Atis

    prop/rpm/mph on a da250

    i did get on plane at 20mph...but at 4300rpms.
  12. Atis

    prop/rpm/mph on a da250

    i bought the boat about 2 months ago...trailered her home and cleaned her. Bottom is clean. Engine runs smooth, fuel filter is new. Trim tabs work and tab pump replaced. boat had 4 adults and a 4yr old on board....life vests, and a small cooler so weight wasnt an issue. Also, 3/4 full fuel amd...
  13. Atis

    prop/rpm/mph on a da250

    forgot to add....v8..260hp with alpha 1 drive
  14. Atis

    prop/rpm/mph on a da250

    so I finally had a nice day to get her out and run her after the throttle cable failed on my maiden. I think the previous owner switched props but put on the wrong prop. I am spinning 4400rpms at 20mph (gps) and thats a little shy of full throttle. I am running 3300 rpm at 10mph. i never made...
  15. Atis

    Newbie just bought a boat! Help!

    i didnt do a survey...so new trim tab pump, throttle cable, battery selector, new vhf radio, rebuilt flip down bench later I am finally in the water....wish i had done a survey. Could have worked on lowering the price
Back
Top