Juno
New Member
- Jul 11, 2015
- 26
- Boat Info
- 2002 Searay Sundancer 300
- Engines
- twin 5.0L MPIs, bravo 3s
Hi guys, for those out there in the Northern regions (I am in Canada) how do you go about fogging your EFI engine.
I have read to NOT spray the fogging oil (I have only had carb engines before so I am used to this procedure).
A merc mechanic at a near by marina told me that they do NOT fog EFI engines....
I also read to make up the EFI mix and add it to the Fuel Water separator filter, disconnect the fuel line from the tank and run the engine until it dies. (seems easy enough)
However then I read to NOT run the EFI dry, but to attach a separate fuel tank with the EFI mix to the motor and run it for 5 mins at 1300rpm.
What do you think the best way to perform the fogging on these engines is?
Thanks in advance.
I have read to NOT spray the fogging oil (I have only had carb engines before so I am used to this procedure).
A merc mechanic at a near by marina told me that they do NOT fog EFI engines....
I also read to make up the EFI mix and add it to the Fuel Water separator filter, disconnect the fuel line from the tank and run the engine until it dies. (seems easy enough)
However then I read to NOT run the EFI dry, but to attach a separate fuel tank with the EFI mix to the motor and run it for 5 mins at 1300rpm.
What do you think the best way to perform the fogging on these engines is?
Thanks in advance.