Wanderer 290
Well-Known Member
Sensors location can be found in the manual I attached. Section 1.7 fig. 1.1
Yes, unplugging the wires and NOT allowing the ends to touch each other or anything else.
Oil check procedure is also in the attached manual. DO NOT SCREW IN, (see attached pic)
The small wire attached to the solenoid on the bottom of the carb is for the antidieseling.
Bleed coolant by filling and running then remove plug on the top of the heat exchanger and topping off probably 3-4 cycles.
A $1000+ dollars could easily be spent throwing parts at the undiagnosed problem and if resolution can’t be found a tech should be called in.
Yes, unplugging the wires and NOT allowing the ends to touch each other or anything else.
Oil check procedure is also in the attached manual. DO NOT SCREW IN, (see attached pic)
The small wire attached to the solenoid on the bottom of the carb is for the antidieseling.
Bleed coolant by filling and running then remove plug on the top of the heat exchanger and topping off probably 3-4 cycles.
A $1000+ dollars could easily be spent throwing parts at the undiagnosed problem and if resolution can’t be found a tech should be called in.