THANKYOU to all for replying to my other threads and all the helpful advice iam haveing an issue with my port drive trim gauge when drive is all the way down the gauge is at 1/2 on the gauge is this a cable issue ? or can this be reset or calibrated? any direction i should go to fix this? thankyou
fracmann
I have the same issue and then the gauge just stopped showing anything. It has to do with the trim sensor that is on the right side of the outdrive. In order to replace the sensor you have to pull the drive. I'm thinking about doing is job or just living with it.
The trim sender can be adjusted. However, it may also just need to be replaced. They cost about $80.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
