Club Sea Ray banner
Cancel
Create thread New Forums

Been doing a bunch of electrical/electronics/appearance upgrades. Just did arch/cockpit lighting

Jump to Latest
81 - 100 of 108 Posts
#81 ·
What bulbs/bases did you use for the tacs? I swapped everything out with led bulbs and new bases. All of the gauges light up except for the tacs. I tried flipping the bulbs 180 degrees, that did nothing. I noticed that the bulbs in the tacs are labeled PC194 with a gray base while all the other gauges are PC161with a black base.
 
Discussion starter · #84 ·
So I was debating on whether to start a new thread or just continue on with this one, since most of what I'm doing this year is cosmetic, other than installing a pair of Fox gateways so that I can get engine data up to the screens.

Updated all of the emblems, destriped the whole hull, replaced cockpit sink, replaced canvas with black.

Pictures kind of suck, since I'm jammed pretty tight into the building.

Image


Image


Image


Image
 
#93 ·
I have the exact same boat and thank you for sharing all of your mods. I have adopted a few like the led lights and USB for accessory ports. I installed an axiom on the side and SeatalkNG converter which allow it to talk to all of the old stuff. Does yours have the 8.1's? I installed vesselview Bluetooth and it works great to get engine data, codes, and actual hours?

Also, When you pulled the fridge, was the coax for cable from the transom drop ran to a splitter there? They disconnected mine when they put satellite in and Id like to put an AB switch in but cannot find where they put the wire and with the fridge in impossible to reach down there.

Finally, where did you get that sink at, its perfect! Nice canvas, I also swapped to black from the Tan and it is like a new boat!

Please keep updating here these are great mods for this great boat!
 
Discussion starter · #94 ·
So, I have the 7.4 Horizons, and will be installing the Fox Marine gateway to get engine data over to the screens.

And yep, on the splitter behind the fridge. Honestly, the fridge is really easy to pull. First time kinda sucked, but now it's a 5-10 minute job to get back there.

Sink (You'll likely have to do a little bit of trimming): https://www.amazon.com/gp/product/B002IZDMWI
Faucet: https://www.amazon.com/gp/product/B01JZ3BY8O


And thanks! I love this thing.
 
#95 ·
Have running some audio cables from the radio to my amp which runs behind the sofa in my 2003 sundancer 300. Any one knowhow to remove the back part o the bench? im assuming once this is done will have some access. any tips or how toos appreciated thanks
 
#96 ·
chris sirizzotti said:
Have running some audio cables from the radio to my amp which runs behind the sofa in my 2003 sundancer 300. Any one knowhow to remove the back part o the bench? im assuming once this is done will have some access. any tips or how toos appreciated thanks
Click to expand...
on the 380, when you remove the seat bottom it exposes a handful of screws, remove those and then the back lifts off to remove
 
81 - 100 of 108 Posts
About this Discussion
107 Replies
37 Participants
Last post:
bracketracer
Club Sea Ray
posts
1.5M
members
64K
Since
2004
Club Sea Ray is the biggest Sea Ray Owners Forum to discuss Sea Ray Boats and Yachts online. Exchange tips, troubleshooting and information with fellow Sea Ray Owners. Message Board for Sea Ray Enthusiasts
Full Forum Listing
Explore Our Forums
General Discussion Sport Cruisers The Tiki Bar General Maintenance/Repair Questions Sport Yachts/Yachts

Top Contributors this Month

View All
S

Recommended Communities

Community avatar for Jeep Forum
Jeep Forum
784K members
Community avatar for AVS Forum
AVS Forum
1.6M members
Community avatar for Subaru Trailseeker EV
Subaru Trailseeker EV
20 members