Water Regulator Inlet

[DarrenC]

While away at Marthas Vineyard this weekend, I was connected to city water inlet. Before leaving i had a friend disconnect the hose from water inlet. However he managed to take out the entire inside guts not just unscrew the hose. Ive tried to put it back together 10 time but now it leake. I think i may be putting it back together wrong. ive tried to get a diagram everywhere and I believe the 2001 sea ray sundancer 310 came with the 44410-1000. can anyone confirm if the water pressure regulator inlet is this model number? If so where i can purchase a new one or how to repair?Ive tried every store in area including west marine, camping supply,ebay, amazon ect.. called Jabsco they said they were discontinued in 2016. I will have to cut out a bigger hole for replacement..

 

[rondds]

They are discontinued and you have to enlarge the hole. A friend went through this same issue in June.

https://www.pumpvendor.com/Jabsco_44410-1000.html

 

[wayne0]

They are discontinued and you have to enlarge the hole. A friend went through this same issue in June.

https://www.pumpvendor.com/Jabsco_44410-1000.html

Thanks for this info. Mine's cracked. Found it on ebay for under $34.

 

[wayne0]

Thanks for this info. Mine's cracked. Found it on ebay for under $34.

Just replaced mine. Easy job. Remove the panel, unplug the one PEX pipe so you can work on it on a table. Enlarge the opening with a saber saw using the provided template. Run the saw slow to minimize melting the plastic! Clean up with a knife if needed. Depending on your installation, you may have to re-configure some plumbing. The new one has a 90 deg. fitting, where the old one was straight. I just had to move an elbow to a different location.