Want heat/oil alarm location and wire color code for 1988 SeaRay Seville>

Discussion in 'Announcements & FAQs' started by slyclops, Jul 13, 2015.

  1. slyclops

    slyclops New Member

    16
    Jul 26, 2008
    Santa Rosa, California
    1988 SeaRay, Seville
    135HP Outboard
    I would like to disable the over temp. alarm on my boat:
    19' 1988 SeaRay Seville #SERA6274L788. 135 Outboard V6 #0B278686.....
    1) I need the location of this alarm module.
    2) I need the wiring color code for this module.
    Now running pre-mix fuel and all oiling equipment & parts have been removed.
    Since the removable of the oiling parts, my over heat alarm has been going off for no reason (temp is 140'-160' per gauge) and is driving me nuts. It turns on, stays on for 15-20 minutes, then goes off, then stays off for an hour or two then comes back on again, temp is always about the same.
    Thank You.....
     
  2. slyclops

    slyclops New Member

    16
    Jul 26, 2008
    Santa Rosa, California
    1988 SeaRay, Seville
    135HP Outboard
    Found alarm module behind dash board, snipped hot wire, no more noise, yay!
     

Share This Page

Show Sidebar