Valence removal

Discussion in 'Modifications/Customizations' started by Painkiller, May 24, 2021.

  1. Painkiller

    Painkiller Member GOLD Sponsor

    67
    May 18, 2015
    Grand Haven, MI
    2005 Sundancer 420
    Twin Cummins 6CTA 8.3
    I am looking at updating the ruffled material on the valences but don't know how to remove them. Does anyone know how to remove them to change the material? Thanks. Front Cabin.jpg Front Cabin 2.jpg Back cabin.jpg
     
  2. Brite Idea

    Brite Idea Active Member

    337
    Nov 5, 2011
    Long Island, New York
    2010 310 Sundancer
    270 Sundancer 2000
    twin 5.0 ECT Bravo III's
    twin 4.3 TBI Merecrusier Alpha Gen II counter rotating drives
    spread the pleating apart and you'll probably find some screws. Carefully mark the backside of them so you put them back in the original location.
     
  3. techmitch

    techmitch Well-Known Member PLATINUM Sponsor

    May 1, 2008
    Chesapeake Bay, Middle River/Frog Mortar Creek MD.
    1999 270 DA
    Twin 4.3s W/Alpa I Gen II's
  4. Blueone

    Blueone Well-Known Member SILVER Sponsor

    Jan 24, 2007
    Lake Erie, Ohio
    2004 420 Sundancer
    Cummins 6CTA 450's
  5. Njlarry

    Njlarry Active Member

    378
    May 9, 2021
    Chesapeake bay
    2000 400 DB
    Cat 3126
    What are you going to put in its place. Almost anything would be lots better.
     
  6. Painkiller

    Painkiller Member GOLD Sponsor

    67
    May 18, 2015
    Grand Haven, MI
    2005 Sundancer 420
    Twin Cummins 6CTA 8.3
    Just getting around to this. I found screws on the trim above the back cabin but could not locate any screws on the trim in the front master cabin. Am I just missing them? Thanks. Tim
     

Share This Page

Show Sidebar