Transom door

[1956olds]

Say anybody near there 86 300 we that can measure the transome door for me ?I am redoing my cockpit cabinet doors and transom door with starboard and am about to order the material and realized i didnt measure the door ,the rest of them are here at home and its an hour drive each way to the boat.Thanks

 

[Beachbob]

My 1989 300 WE is 10 mins away. If you think it is the same, I'll get you the measurements. Let me know.
boblonthebeach@yahoo.com

 

[1956olds]

it should be the same how about a pic to go with so i can be sure.these guys charge by the foot for thjis stuff.thanks

 

[AKBASSKING]

I re-did mine with 3/4 in starboard. I can measure and take a pic tonight.

 

[1956olds]

ok thanks abassking ,do you think a da and we were the same? I think so.By the way I was following your thread on bottom painting as i striped my 26 ft bayliner and epoxied it lastr spring .I used pettit and hydrocote but i striped it with a wetsand blaster then a bit of sandpaper.Bet your glad to be finished.

 

[AKBASSKING]

My door is 15 1/2 inches wide by 22 3/4 inches high.

real glad its over

 

[1956olds]

Thanks again akbassking ,the door looks great.Is it in ak or not?I see you have a lot less snow than we do.I am going to soroc plastics this afternoon to have all my cockpit doors remade .Mine arent terrible but i wont have to worry about them ever again.And they will look good with all the new vynil and seating i've been slaving on all winter.

 

[1956olds]

PS; did you have a nice visit with your baby?

 

[AKBASSKING]

Thanks again akbassking ,the door looks great.Is it in ak or not?I see you have a lot less snow than we do.I am going to soroc plastics this afternoon to have all my cockpit doors remade .Mine arent terrible but i wont have to worry about them ever again.And they will look good with all the new vynil and seating i've been slaving on all winter.

My door was that crappy laminated wood that SR used, so I have been replacing most of that crap with starboard. My next project is the bridge and take out all thy plywood and replace it with 1/2 starboard and clean up the wiring mess underneath.

The boat is in NC at my parents. I will soon be taking it to portland OR, then on to Alaska in a few years.

Glad I could help.

Good luck with your project.