ronaldsndrs
New Member
looking for advice on where to install the THRU-HULL transducer... to clarify best location to install a inboard transducer.
Transducer Installation on a Sea Ray 240
- Thread starter ronaldsndrs
- Start date
Fishnut
Member
- Jan 30, 2008
- 509
- Boat Info
- 2006 240 Sundancer
- Engines
- 5.0 Mercruiser with Bravo III Drive
ronaldsndrs
New Member
1999
Ronald, come on, gots to give us some more info! Deck boat, bow rider, cruiser?
But, in general, about 1 foot on either side of the keel - approximately even with the front of the engine. Anywhere you have a nice flat spot, really.
But, in general, about 1 foot on either side of the keel - approximately even with the front of the engine. Anywhere you have a nice flat spot, really.
Moose
New Member
- Oct 23, 2006
- 363
- Boat Info
- 2004 260 SunDancer, GenSet, Lowrance GPS/Fish Combo
- Engines
- 350 Magnum w/B3
As Dennis says, a flat spot in front of the engine and not far from the centerline. Also make sure you follow manufacturers instructions as to testing the unit before epoxy. Must be solid fiberglass! Lowrance has great instructions. Maybe you can access online.
ronaldsndrs
New Member
ok! sorry a 240 Sundancer
ultratiger89
New Member
there should be a spot designated for the transducer. I know when I put one in my Baja there was a flat "level" spot for it, meaning there was no angle to the place to mount it, it should point straight down, not at an angle
