Setting up bennett

[billnpat]

Do you set it once.forget it or every so often re- adjust because they go off adjustment after a while?..my bennett dash unit port side upper arrow light was on steady after a hard turn to port and the boat was listing to starboard yesterday after straighting out for a good 1/4 mile, but then after throttling down entering the marina it seemed to re=adust it self....:huh:

Lost the instructions on setting it up out in the water when its installed

where can i get them??

 

[Tabman]

BillnPat,

Here is a link to the instructions for the Auto Tab Control http://www.bennetttrimtabs.com/pdf/instIcon/AC3000_instructions_final.pdf

You should not have to reset the system. When you made the hard turn and the boat healed over the system tried to level the boat out and raised the port Trim Tab all the way (that is what the steady arrow light indicated). If you do a hard turn the system may not keep up with it and you may simply want to trim the boat out using the manual Trim Tab controls, and then reengage the Auto Tab Control.

Tom
Bennett Marine

 

[billnpat]

BillnPat,

Here is a link to the instructions for the Auto Tab Control http://www.bennetttrimtabs.com/pdf/instIcon/AC3000_instructions_final.pdf

You should not have to reset the system. When you made the hard turn and the boat healed over the system tried to level the boat out and raised the port Trim Tab all the way (that is what the steady arrow light indicated). If you do a hard turn the system may not keep up with it and you may simply want to trim the boat out using the manual Trim Tab controls, and then reengage the Auto Tab Control.

Tom
Bennett Marine

Great.....Thanks Tom.......