Sea Ray 310 sunpad Filler Cushions

[DarrenC]

Hello, I have a 2002 Sea Ray Sundancer 310. I have searched everywhere trying to see what the filler cushions that go on table in cockpit to convert it into a sunpad look like. I have 4 rectangle cushions that came with the boat I figure those are for the aft cabin bed and the dining table to convert to bed. Is the sunpad filler cushion one cushion or 2? Any help would be appreciated and a photo would be even better. Thanks

 

[jakevader95]

They are a pair, semicircular, white, and have flaps to snap to the bottom of the cockpit table. Uses the short table leg to convert the cockpit table to a sunpad extension of the seat.
Same thickness as cockpit seat cushions.

 

[DarrenC]

Thank you very much. Is it possible you could post of picture of the cusions? Also any idea where I could buy them?

 

[dvx216]

you might be better off to take the table to an upholstery shop and have one made.

 

[Civility]

Thank you very much. Is it possible you could post of picture of the cusions? Also any idea where I could buy them?

Hey Darren... Old post but how did you make out with the cushions for the cockpit table? I'm in the same boat!! LOL

 

[DarrenC]

Hey Darren... Old post but how did you make out with the cushions for the cockpit table? I'm in the same boat!! LOL

I had a cushion made. Brought table to the guy and he made a cushion by tracing out the table. Came out good. Just have another issue. I use the short table pole but it’s still rocky with cushion on top. Maybe you could instruct me the right way to set it up.

 

[bobeast]

I had a cushion made. Brought table to the guy and he made a cushion by tracing out the table. Came out good. Just have another issue. I use the short table pole but it’s still rocky with cushion on top. Maybe you could instruct me the right way to set it up.

If you look at the underside of the table, there should be a couple of drop-down legs that will stabilize the table when used as a sun-pad base.

 

[DarrenC]

If you look at the underside of the table, there should be a couple of drop-down legs that will stabilize the table when used as a sun-pad base.

Yes it does I fold them down then put the pins in holes but it’s still wobbly. I’m concerned it’s going to crack table. If you need a cushion made I can get you in touch with guy who made mine. It was around 200.00

 

[bobeast]

Yes it does I fold them down then put the pins in holes but it’s still wobbly. I’m concerned it’s going to crack table. If you need a cushion made I can get you in touch with guy who made mine. It was around 200.00

If it's wobbly, I'd check to make sure the short table leg is seating completely or that a PO didn't replace it with the wrong length. Mine is pretty stable.

 

[Civility]

Yes it does I fold them down then put the pins in holes but it’s still wobbly. I’m concerned it’s going to crack table. If you need a cushion made I can get you in touch with guy who made mine. It was around 200.00

Sounds like a plan. Where are you and the fabricator located?