Sea Ray 215 removable table dimensions

[Sea Ray 215]

Recently got a 1996 Sea Ray 215, but it did not come with the table that supstitutes as a support for the cushions in the vbirth. If someone with a 215 could give me dimensions, I could have one made. Photos would also be handy. My email address is searay215@comcast.net I have a buddy who is handy with wood..... I'd bet Sea Ray wants a bundle for one of those. Just trying to save some $. Thanks in Advance

 

[CliffA]

Recently got a 2006 Sea Ray 215, but it did not come with the table that supstitutes as a support for the cushions in the vbirth. If someone with a 215 could give me dimensions, I could have one made. Photos would also be handy. My email address is searay215@comcast.net I have a buddy who is handy with wood..... I'd bet Sea Ray wants a bundle for one of those. Just trying to save some $. Thanks in Advance

the table in my 1998 215EC is likely the same table for your boat....if so it has an irregular shape....one side is slightly wider that the other....i can draw an outline of my table on some wide paper that i have if you want me too...if so shoot me a PM with an address to send it to and i will make the template this evening after work...

 

[Lazy Daze]

Just an FYI: It looks like you have a 1996 215EC, not a 2006. It was a different hull design in 2006. In '98 (Cliff's boat), it would indeed be the same as '96.

 

[CliffA]

this is not the best pic but i found this by a search on the net to give you an idea what the table looks like....

 

[Lazy Daze]

It shouldn't be too hard to make a template with cardboard right there on the boat, either.

 

[Sea Ray 215]

Yes my bad it is a 1996....sorry guys.

 

[CliffA]

i have sent you a reply to your PM....just let me know what all you need...


Dennis is right...it would be fairly easy to make a cardboard template...the only tricky part may be the shape and placement of the 'hook' under the table to keep it in place when used as a bed if you do not know what it looks like....also the location of the pole base would be difficult to mark exactly as the original without a template but the location of the base is really not that critical...it could be off several inches from the original configuration and still be OK...