Removing Bench Seat for Access - 2004 SR 200 Select

[steve8650]

I have a 2004 SR 200 Select and need to access the bilge pump which is not working. Worked last year, checked fuses 1st and both 7.5 were broken so replaced those. Light on switch comes on but nothing from pump. Can’t reach it by leaning in so looking to remove the bench seat or at least the back part of it. How do I go about doing that? Thanks

 

[dlvwill]

I have a 220 Select from the same year so I assume they are set up the same. Lift up the port jump seat and remove the filler panel on the left by removing the 2 screws that go into the floor and the 2 screws at the back. Remove the bench seat and along the inside front will be screws that need to be removed that go into the floor. Remove the 2 screws on the back center filler panel and then the 2 screws on the back side of the filler panel in the engine compartment that go into the floor and remove filler panels. Disconnect the motor hatch support cylinders and lay the hatch back. Then have 2 people lift the bench seat frame straight up and out.

 

[steve8650]

I have a 220 Select from the same year so I assume they are set up the same. Lift up the port jump seat and remove the filler panel on the left by removing the 2 screws that go into the floor and the 2 screws at the back. Remove the bench seat and along the inside front will be screws that need to be removed that go into the floor. Remove the 2 screws on the back center filler panel and then the 2 screws on the back side of the filler panel in the engine compartment that go into the floor and remove filler panels. Disconnect the motor hatch support cylinders and lay the hatch back. Then have 2 people lift the bench seat frame straight up and out.

Thanks for the reply - my configuration is different, there is not jump seat and bench goes across entire back. Is the seat back all one piece or are there sections to it. I have a brackets at back corners of the bench. Is it better to remove the screws from the wood backing of seat back or from the fiberglass sides? Are there screws in the fiberglass seat support that need to be removed from it attaching to floor?