Pre wired spot light on 400 ec

hillsideshortleg

Active Member
Feb 5, 2012
254
Lake Pend Orielle, Idaho
Boat Info
92 Express Cruiser /89 Sea Ray 280 Sundancer
Engines
489s / 350's Mercruiser drives
I am wondering if the spot light would be pre wired on a 1992 400 EC. If not is there an easy route to run the wires back to the helm from the pulpit.
Thanks
 
Easy route I would say not.

I took the port side path for the tv I installed on the stbd side in the v-berth. Challenge I had with the stbd side was the bunks. Suppose you might get away with pulling up some carpet or getting lucky drilling holes from the bunk storage into the v-berth stbd closet, and then again from bunk storage to settee storage. Lots more wires and space on the port side.

If you go the Port side path - get behind the v-berth Tv/closet, behind medicine cabinet, then behind tv in galley. There is a factory tube that carries the tv antenna line out to the cockpit. You can use that to get to the back corner stove/fridge area - you will need to cut/open that tube before it exists to cockpit and fish your wires out. You will need to pull the fridge though so you can continue the path across to the stbd side, behind the electrical panel, then out to the cockpit/helm. Its not fun - I only did it because I was running HDMI, Coax, and Cat5e to both TV’s.

Hopefully you can find a path down the stbd side!
 

Forum statistics

Threads
113,187
Messages
1,428,226
Members
61,099
Latest member
Lorenzo512
Back
Top