power trim issue

d-reed

Member
Oct 23, 2018
53
Western Ma.
Boat Info
1996 Sundancer 250 DA
Engines
Gen 6 454 carb Bravo 1
So over the winter I installed new trim and limit switches. I am in need of a wiring schematic for the sensors. The boat harness ends do not have any connectors so I am not sure what color the wires are.
I was able to figure out the limit wires, but I am unable to figure out where the other sender wires go? If someone can post one for a 96 Sundancer 250 that would be great!

Thanks
 
Look at the stbd side up front where the 50A cb and slave solenoid is.right above the fuel sep. Your looking for a whitish plastic block with a brown or brown W/ white stripe. thats the sender wire to the gauge , the other wire goes to ground on a bolt or nut there
 
Look at the stbd side up front where the 50A cb and slave solenoid is.right above the fuel sep. Your looking for a whitish plastic block with a brown or brown W/ white stripe. thats the sender wire to the gauge , the other wire goes to ground on a bolt or nut there
Figured it out. But the setup you speak of is nothing like mine. Thank you though
 

Forum statistics

Threads
112,945
Messages
1,422,739
Members
60,928
Latest member
rkaleda
Back
Top