main a/c panel

[Saverio]

has anyone replaced the green neon lights for the panel. I have two and they are really dim and flicker.

 

[Stee6043]

You can buy replacements at Flounder Pounder...

 

[Cocktail Time]

Yes and it is super easy. They are only a couple bucks too. Open the AC panel, disconnect the two wires that are on each end and pop the fixture out. Reverse procedure to install new ones.

 

[Saverio]

anyone find them on amazon??

 

[SeasNT]

Yes and it is super easy. They are only a couple bucks too. Open the AC panel, disconnect the two wires that are on each end and pop the fixture out. Reverse procedure to install new ones.

Same issue a few years ago, I replaced the genset lights as well while I had the panel open. Disconnect the shore power before doing anything!

 

[Chris-380]

anyone find them on amazon??

here is a link
https://www.fpmarine.com/Panel-indicator-lights-p/light rect green 125vtabs.htm

 

[hughespat57]

FYI - when working in the panel, disconnect the shore cables for safety, otherwise one side of the main breakers could still be live.

 

[Cocktail Time]

anyone find them on amazon??

Negative. Found red, with stainless bezel. But hell, they are only $6.00 each on FP.

 

[oh no its Joe again]

Hi, i need to get behind that panel to access a stereo amp. if i remove the 4-6 panel screws in the front, is there enough room to lower it or pull it forward, for access without "f---king some thing up"

 

[Cocktail Time]

Hi, i need to get behind that panel to access a stereo amp. if i remove the 4-6 panel screws in the front, is there enough room to lower it or pull it forward, for access without "f---king some thing up"

It should be hinged so that it will swing open and you can access the wiring. Make sure the shore power is disconnected and the genset off before doing so.

 

[carterchapman]

here is a link
https://www.fpmarine.com/Panel-indicator-lights-p/light rect green 125vtabs.htm

Chris - I needed ones with wires instead of tabs...:

https://www.fpmarine.com/electrical-panel-indicator-light-lamp-p/light rect green 250vwire.htm

Then I didn't have to use spade connectors...

 

[Saverio]

The link is for the 220v ones

 

[Saverio]

The link is for the 220v ones

 

[Saverio]

The link is for the 220v ones

 

[brewster16]

I too need these...thanks for the link. I guess I'll need to open the panel to see if I need 250V wired or 125V spade.

 

[Saverio]

thanks
just ordered two

https://www.fpmarine.com/Panel-indicator-lights-p/light rect green 125vtabs.htm

 

[brewster16]

I too need these...thanks for the link. I guess I'll need to open the panel to see if I need 250V wired or 125V spade.

Just ordered two 250V wired lights....and after the painful process of ordering through Flounder Pounder and their $25.00 minimum and the ridiculous shipping fee it made me long for Amazon!