trdehmer
Member
I installed the Vesselview Mobile device on my 2003 280 Sundancer which has a single 496MAG S/N 0M376155. After the install and starting the boat I immediately have 5 fault codes. How do I determine if they are an issue and even applicable to my engine? Idles around 670-700RPM (is that normal, or low?).
-Code 451-25 Pilot Pressure (The input circuit for the sensor is below the valid limit)
-Code 701-24 Level sensor tank A (The input circuit for the sensor is below the valid limit)
-Code 1031-24 Steering Position (The input circuit for the sensor is below the valid limit)
-Code 1012-25 Engine or drive trim position (The input circuit for the sensor is below the valid limit)
-Code 702-24 Level sensor tank B (The input circuit for the sensor is below the valid limit)
Thanks in advance!
-Code 451-25 Pilot Pressure (The input circuit for the sensor is below the valid limit)
-Code 701-24 Level sensor tank A (The input circuit for the sensor is below the valid limit)
-Code 1031-24 Steering Position (The input circuit for the sensor is below the valid limit)
-Code 1012-25 Engine or drive trim position (The input circuit for the sensor is below the valid limit)
-Code 702-24 Level sensor tank B (The input circuit for the sensor is below the valid limit)
Thanks in advance!