Driver seat

Discussion in 'Sport Cruisers' started by Swedish Sea Ray, Nov 2, 2019.

  1. Swedish Sea Ray

    Swedish Sea Ray New Member

    3
    Nov 2, 2019
    Sea ray 290 1996
    Volvo Penta D4 300
    Hello, first post
    I own a sundancer 290 -96 and i want too remove the driver seat.
    How too?
     
  2. Groucho

    Groucho Well-Known Member

    Jun 11, 2008
    Albany/Lake George NY
    2004 320 DA
    6.2 V-Drives

    There should be an access hole or compartment under the seat. It has to be bolted on somewhere on the bottom.
     
  3. boatmailster

    boatmailster Active Member

    May 13, 2007
    NY
    none to share
    none to share
    If you dont see any nuts on underside then there is two options.
    Seat was installed using blind nuts, toggle bolt nuts or something similar. If that is the case simply unscrew the base
    Other possibility is that there are nuts and to access them you either have to drop down head liner or install access plate.
     
  4. Swedish Sea Ray

    Swedish Sea Ray New Member

    3
    Nov 2, 2019
    Sea ray 290 1996
    Volvo Penta D4 300
    The seat is mounted on sliding rails like a car seat, there has to be a way to push it beyond the end points?
     
  5. Sublimetime

    Sublimetime Active Member

    694
    Oct 22, 2007
    clifton nj
    420 da
    454
    look close at the end of the slide, there is a screw used as a stop.
     
    Swedish Sea Ray likes this.
  6. Swedish Sea Ray

    Swedish Sea Ray New Member

    3
    Nov 2, 2019
    Sea ray 290 1996
    Volvo Penta D4 300
    Perfekt, thanks
     
  7. boatmailster

    boatmailster Active Member

    May 13, 2007
    NY
    none to share
    none to share
    Ooo.., you didnt want to remove whole seat! You can either unscrew it from pedestal or slide it from tracks. There is limit stop on tracks - either screw or rivet. If you have a rivet - drill out and replace with screw when reinstalling.
     

Share This Page

Show Sidebar