Bilge Fuse for 2008 350 Sundancer is? (Or is there even one?)

[Drifter85258]

I thought i had a post elsewhere on this but I can't seem to find it. I have been trying in vein to find the fuse for the bilge. Background, the bilge (either one) work if I pull the float switch. The breaker shows as "on". The button on the dash does nothing. Doesn't light up, etc. I looked and it appears that there is one main cable that plugs into the back of the panel on the dash so assuming it isn't a connection issue there. Open to others experience / ideas? I looked at the manual and it shows a fuse box on the forward, engine room bulkhead but my boat doesn't seem to have that fuse box? I looked at the fuses connected to the battery and all seem good. Is it one of them? I could just start replacing just in case? Could it be one of the connections? Thanks so much!

 

[ziekman@cox.net]

Are you thinking you have a breaker, "and" a fuse? My boat has a high water and low water pump in the bilge. Only the low water pump has a switch at the helm. The high water pump has an audible alarm.

 

[Drifter85258]

Are you thinking you have a breaker, "and" a fuse? My boat has a high water and low water pump in the bilge. Only the low water pump has a switch at the helm. The high water pump has an audible alarm.

thanks and yes I have the two bilges you mention (hi and low) and same set up as you (low is button and the one at the back of the bilge). I assume this means no inline fuse? That was my only hope!

i read on some other post someone had a bad connection. The only connection I can find (for low water), is the two water proof connectors by the pump. I may pull them apart and scrub / grease. Was hoping someone else had figured out this on before. Appreciate the help as always.