Alpha one gen 1 shifting adjustment questions

[cloud_master]

New to me 1990 280 da. Just had the drives off, and had the prop seals, pumps serviced by a Merc mechanic. Reinstalled the drives yesterday. In checking forward and reverse engagement, I wasn’t getting reverse on one side. Went through the cable adjustment procedure. Ended up having to move the drive cable up in the slot to max. I found still not wanting to engage reverse at idle reverse. It will engage reverse at full throttle reverse as per how it’s set up in the book. So apparently I am not getting enough movement of the drive cable in reverse at idle as compared to full throttle. I can’t see how having the boat in the water would change the fact I don’t have enough reverse engagement at idle. What can I do about this? I’m sure all my cables are not as healthy as they could be and have more slop than the should. I did mess with the remote cable adjustment to get the reverse to lock up at idle however it then changes the forward gear engagement. Also, I can see the engine cut off switch coming off of neutral when trying to adjust the remote cable for reverse engagement at idle.

I’m not sure what else I can do other than start replacing cables and/or the dog clutch.

 

[Thornton69]

Is the one you are having problems with a counterrotating drive? Believe they need to be put in reverse to remove the drive rather than forward. Is it possible a mistake was made and the lower cable or linkage was damaged?