5ecd issue

[Mustangdriver1968]

New to the forums and new to me 2007 260SD with 50 hours on the Genie. When I purchased the boat I knew the generator was not running. I was able to get the genarator running by rebuilding the high presure fuel pump. Since then I put about 6 hours on it during its first outing without a hitch. The next time I went out the generator started right up but shut down after a minute or two.

I checked for error codes but the ADC display was only showed dots and dashes, not even the current run time would show up and fuse 6 is blown. I have a replacement ADC on order but would hate to plug it in only to have fail. Does anyone have any thoughts on what I should check before installing the replacement? Is there some other way to read the fault code?

 

[DrPringle]

The manual recommends replacing the injector when the fuel pump is replaced
Was that done ?
Mine quit working after the fuel pump was done and the fix was getting a new injector
Those pumps dissolve from the inside out plugging the injector up
Just a thought and cheap to replace

 

[Mustangdriver1968]

Yes, the injector, LP pump, filters, impeller, and coupling (little orange/yellow) thing were changed. I just can't figure out why the ADC display stoped working.

 

[DrPringle]

I spent three years throwing parts at mine
Finicky things when they havnt been used

 

[Mustangdriver1968]

I spent three years throwing parts at mine
Finicky things when they havnt been used

Well for now I just hope to find a way to read the fault code.