Hi I have underwater lights when I put direct power to them they work where would my switch be for these lights on AC 1 or AC2? Also on my V Drives should I put Zincs on the shaft never came from the factory I was told it could cause a vibration issue? Has anyone updated there C80 and smart vessel.
2008 340 Sundancer
- Thread starter Sunrise
- Start date
- Mar 26, 2017
- 140
- Boat Info
- 2003 SeaRay 420 Sundancer
2003 SeaRay 320 Sundancer
- Engines
- Cummins 6CTA8.3-M3
Mercruiser 350MPI
My boat has a separate little switch for the under water lights. No to the shaft zincs for the reason you stated. And I got rid of the C80 and went with Garmin.
Craig
Well-Known Member
- Feb 8, 2007
- 1,044
- Boat Info
- Boatless
- Engines
- Boatless
My lights are on aft acc on the port switch pad. No shaft zinc for me. I updated to Axiom 9 and Vesselview 502.
KevinC
Well-Known Member
We went dual axiom 9 with a quantum up top and absolutely love it. Winter project is bringing in smartcraft via a gateway.
Planning on doing a full write up of the install when I have time. We also fabricate our own panels and plan to swap out the one at the guages too.
-Kevin
Planning on doing a full write up of the install when I have time. We also fabricate our own panels and plan to swap out the one at the guages too.
-Kevin
