2008 290 guage issue

[vze26n49@verizon.net]

The starboard engine guages on my 2008 290 Sundancer have failed in the position that shows temp, voltage, and oil pressure even with the key off. The tach guage read the RPMS but digital information in the center is blank. Multi function guage (far right) the night light is on even with the key off.
Any suggestions?

 

[magster65]

The only thing I can think of is try powering down the whole boat (batteries off / no shore power), let it sit for a few minutes and power it back up.
Failing that you probably need a shop to nail down the exact cause...

 

[vze26n49@verizon.net]

The starboard engine guages on my 2008 290 Sundancer have failed in the position that shows temp, voltage, and oil pressure even with the key off. The tach guage read the RPMS but digital information in the center is blank. Multi function guage (far right) the night light is on even with the key off.
Any suggestions?

Tried that a while ago with no luck. Dealer claims I should disconnect the leads from them for a short time as if to reprogram them. Going to try later this evening.

 

[JV II]

I had a problem that required a reboot of the Smart Craft. To do that you need to remove the blade type fuse on your battery positive terminal for 30 seconds and then reinstall. See if that works. Welcome to the board.

 

[vze26n49@verizon.net]

Pulling the fuse solved the problem!
Thanks!

 

[JV II]

Pulling the fuse solved the problem!
Thanks!

Excellent. My pleasure.