Does anyone know the approximate weight of a 2006DA on a trailer with a 496Mag and genny? Also the height on trailer? DA with arch obviously. I am planning on moving up from my 2007 240DA. I love the current storage facility im at as its brand new with concrete floors and im the first tenant since it was built. My concern is the height, the door height on the Unit is exactly 12'. Any info will be appreciated
2006 260DA weight and height on trailer
- Thread starter jerzyjr
- Start date
wyrman
Well-Known Member
- Jul 12, 2012
- 1,922
- Boat Info
- 2007 310 Sundancer
- Engines
- Twin 350's, V drives
2003 Fisher 17 aluminum
90hp Honda 4 stroke
I don't know the exact weight but mine is something like 7900 dry without the trailer with the 350 mag.
My height on an EzLoader trailer is around 12'2" or 12'3".
With the exception of being a brick to pull, it pulls outstanding with the triple axle trailer, and very little tongue weight. I do however pull with an F350.
My height on an EzLoader trailer is around 12'2" or 12'3".
With the exception of being a brick to pull, it pulls outstanding with the triple axle trailer, and very little tongue weight. I do however pull with an F350.
bbwhitejr
Well-Known Member
Dry weight is listed as 7500 lbs in the owner's manual w/ 350 mag for me-add gen(250), AC(150), fuel(500), water(200), batteries(3-170), engine fluids(15)=8300 + electronics, loaded fridge, cooler, grill, and other junk, I am likely pushing 9500 lbs+. Add in a 1000 lb tandem axle aluminum I-beam trailer and on a loaded day, I am between 10,500 and 11k.
I have a Glomex antenna on top of my arch and park in a boat shed that is 14' tall at the peak. I would be a little closer to 13' than Greg. Gunwales are about 3" above the trailer fenders and 15" tires/wheels.
I do not think you will clear a 12' door sill. I will try to get some real measurements and post later tonight.
Bennett
I have a Glomex antenna on top of my arch and park in a boat shed that is 14' tall at the peak. I would be a little closer to 13' than Greg. Gunwales are about 3" above the trailer fenders and 15" tires/wheels.
I do not think you will clear a 12' door sill. I will try to get some real measurements and post later tonight.
Bennett
wyrman
Well-Known Member
- Jul 12, 2012
- 1,922
- Boat Info
- 2007 310 Sundancer
- Engines
- Twin 350's, V drives
2003 Fisher 17 aluminum
90hp Honda 4 stroke
That dry weight sounds more like it, but I did measure the height a few years ago as I had to "remodel" our barn to fit it in and mine was somewhere around what I posted. That's without anything other than the mast light in the down position.
Woody
Well-Known Member
Page 35 shows 10'10" keel to top of arch. I doubt you'll find a trailer that'll carry the boat less than 14" off the ground, doesn't look like she'll clear a 12' door.
http://www.searay.com/boat_graphics/electronic_brochure/Company1729/1C1_23_74DEJAKXM8I.pdf
http://www.searay.com/boat_graphics/electronic_brochure/Company1729/1C1_23_74DEJAKXM8I.pdf
importmonkey
Opinionated Member
- Jul 9, 2015
- 1,056
- Boat Info
- 2005 260DA (sold)
2007 44DA (sold)
1989/2015 Hatteras 65c
- Engines
- 12v92TA
To be safe, I use 10,000lbs and 13'6" tall. With glomex and venture trailer, loaded and full.
Sent from my SM-G930V using Tapatalk
Sent from my SM-G930V using Tapatalk
Last edited:
bbwhitejr
Well-Known Member
Just measured, with the Glomex on top, I am 13'1" +/- 2". Not a very easy measurement to take.
Bennett
Bennett
Woody
Well-Known Member
That's interesting. I looked at the dimensions for my 280DA, 10'7 keel to top of arch, which is three inches less than the 260DA. I take the Glomax off, when on my trailer the height from ground to top of Glomax mount is 12'7. When I built my storage building I put in a 13' OH door.
