2005 Sea Ray 390MY Salon Speaker Cover

Discussion in 'Announcements & FAQs' started by Ladyadelineyacht, Feb 8, 2015.

  1. Ladyadelineyacht

    Ladyadelineyacht New Member

    3
    Feb 8, 2015
    Baltimore MD
    2005 Sea Ray 390MY
    Cummins 480CE
    Can anyone provide a DIY procedure to remove the cloth covering in the Salon? It has an apparent water stain and I need to clean/replace it and isolate where the water came from.

    Much appreciated...

    Kevin
     
  2. alnav

    alnav Member GOLD Sponsor

    780
    Sep 16, 2009
    West River, MD
    40 MY
    QSB 425
    Kevin, I had mine fixed this past year, assuming you mean the speaker covers. I wasn't there when it was done but I believe the tech said they came right out with a little prying. As to where it came from, my problem was a fitting in the windshield washer lines that ruptured, apparently from improper winterization. This was probably my fault as I had done the winterization and probably forgot to run the washers.
     
  3. Lazy Daze

    Lazy Daze Well-Known Member TECHNICAL Contributor GOLD Sponsor

    Apr 21, 2009
    PA
    Various
    Various
    Assuming -- :) -- it's the same type of speaker cover in my boat and all the others I have seen, Al is correct that they just fit in by friction. Sea Ray makes the frame for the cover and then covers it in fabric then just pushes it into the hole. Usually I can pry it out with just my fingers.
     
  4. Ladyadelineyacht

    Ladyadelineyacht New Member

    3
    Feb 8, 2015
    Baltimore MD
    2005 Sea Ray 390MY
    Cummins 480CE
    Thanks Al....
     
  5. Ladyadelineyacht

    Ladyadelineyacht New Member

    3
    Feb 8, 2015
    Baltimore MD
    2005 Sea Ray 390MY
    Cummins 480CE
    Thanks Dennis
     

Share This Page

Show Sidebar