1990 Anchor Rope Locker Hatch!

[CV-23]

Mine has been destroyed by sun and weather. It is not 6" or 8"! The locking hatch is 6.5" with an outside diameter of 8 7/8". Screw spacing is 8 1/4" apart. Hole opening is 7 1/4". Can't find anything that works. Any help would be great...This is a 270 Sundancer....Thanks, Mike.

 

[CV-23]

Part was made by Viking Maine, CA if that helps.....they are out of business.

 

[Lazy Daze]

You're talking about a "deck plate"? If you can't find one that fits... TH Marine... Beckson... SeaDog... etc... Just get one size larger and cut the hole a little bigger. It'll take 10 minutes to make the hole bigger and that's better than spending hours searching online.

 

[Gofirstclass]

Dennis, you seem to always be johnny on the spot with good advice. You be a nice guy to have hangin' out on CSR. Thanks.

 

[Lazy Daze]

Dennis, you seem to always be johnny on the spot with good advice. You be a nice guy to have hangin' out on CSR. Thanks.

You are too kind!

I'd like to say that "I'm just THAT smart"... but it really boils down to making (many?) mistakes and learning from them... well, sometimes I have to be "learned" a few times before it sinks in...

 

[Gofirstclass]

Yup, if y'all been fetched up right when you get to be an old guy like me y'all knows some stuff! Now if I could only remember it.

 

[Lazy Daze]

Yup, if y'all been fetched up right when you get to be an old guy like me y'all knows some stuff! Now if I could only remember it.

Ha!

Different subject, but I always like your pictures that you post. They always seem like they're simply two people, enjoying life. Wait a minute... maybe it IS the same subject.... hmmmmmm.........