1987 Sea Ray 250 CC Interior Question

[John Per]

I am trying to take off the back piece of upholstery on my 1987 Sea ray 250 CC the part behind the engine cover. It is the main piece of upholstery that is in the back of the boat. I have taken it down to the back but can not figure out how to take it out so can get at the engine easier.

Is there any manuals or instructions on this?

 

[Drstrangelove]

I've got a 89 and I'll assume it's similar. Flip the aft seat cushion up and remove the screws holding the upholstered panel to the angles and keep them safe. Remove the screws attaching the two center braces to the transom blocks and keep them. If you have a trim tab power-pack attached to one of the center braces remove the screws and support the power pack so it doesn't hang from the tubing. There were also a couple screws at the lower edge on the sides, get them free and save them too.

The panel should be free at this point, I had to flex the center towards the bow and tilt it to allow it to lift out.

Just joined today so if you got this figured out in the past three months, good to hear!