wiring

  1. Lou R

    Dimmer switch wiring

    Happy New Year, I need a little help, I’m replacing the original dimmer switch on my console which has 3 wires, (red, black and blue) with a new dimmer switch that only comes with two wires (red and white). Is there a way to wire a two wire switch to three wires? Or do I need a different switch?
  2. coolmaven

    Adding Subwoofer to the stock Calrion XMD3/MAA120-2 AMP

    I'd like to simply add a subwoofer to my stock Calrion XMD3/MAA120-2 AMP set-up on my '04 280D. Thinking of installing this under the cockpit sink...
  3. S

    Steering wheel controls - newer Clarion Radio

    My older CMD4 Clarion Radio finally died, so I upgraded to the newer M508 Clarion radio and new MW1 Clarion wired remote control. I would like to be able to splice in the wires so the new radio can use the steering wheel controls. Does anyone know which wires need connected to use the existing...
  4. S

    Battery Wiring diagram

    Hello, Stupid question here because I didn't take a picture before I took them out. What is the correct wiring setup for a 2011 185 sport for the batteries. I assume a positive from the switch goes to each battery and then the 1 negative goes to one of the 2 and you connect to the other...
  5. G

    Wiring Schematic for 1989 Searay340 Sundancer

    Hello - I'm new to the forum and new to boats. We just got this old gal and need to run down some wiring issues. Anyone have any luck finding a wiring schematic or diagram for a boat this old? I was able to download the owners manual off of SeaRays website, but no joy for wiring diagrams for...
  6. S

    Adding New Rocker Switches

    Adding new rocker switches sounds easy - right? I have read threads on this forum but have not found an answer to my question, so turning to this group for some guidance. I am looking at purchasing newmarine etched rocker switches...
  7. MPL

    Running wires

    Just trying to run a wire from the port side electronic panel to the helm on my ‘14 350DA. I have the tv and all the access panels out and it doesn’t seem to have any access conduit. Wires go all the way around the bow but I can’t access any of the bulkheads to drill new holes following those...
  8. dmeyers_99

    Starboard start issue. Need advise

    I have a 2005 390 DA Sundancer. This season I had an issue with the starboard engine not starting using the rocker switch at the helm. If I used the emergency switch I could start the engine without an issue. So I proceeded to change what I thought could be causing the issue. Started with...
  9. S

    Wiring on 2005 AJ 270

    I am having some wiring issues on my Amberjack. The first one is the fuel gauge reads E all the time. (it has done this since I bought the boat) I took the sending unit out and checked it with an omh meter, I tested good when the float was moved up and down. I then checked the voltage on the...
  10. T

    Cockpit Lights Wouldn't Turn Off now Won't Turn On

    I have an 88 sea ray weekender that I shipped from PA to GA, my dad owned it for about 15 years. When I got it in the water, we started having new issues right away. I think some things got knocked around during the trip. One of the issues was that the cockpit lights would not turn off. I...
  11. JohnEGraham

    Bilge wiring question 2 sets of wires BLk & BlK Blk & Brown

    Hi, Re-wiring and replacing the bilge pump/float on my 98 Sundancer. I have schematics but the colors are different I have a set of blacks together and a black and single brown together coming from the rear of the boat under the engine ( No reds to be found.) 1) i found the hot all the time...
  12. H

    95 Sundancer 270 outlets not working

    I plugged a heater in the cabin GFI outlet above the fridge. (Same as every year) When I got back to the boat the GFI outlet would not reset. Not even click. The cover even look a bit burned. I replaced the outlet with a new GFI but the same thing is happening. There is a green light on the new...
  13. D

    Wiring for 400 Sundancer ignition switch

    I have a 1997 400 diesel Sundancer. I recently replaced the dash panels, which requires removing all the wiring to the toggle switches and then reattaching the wiring to the switches in the new dash panel. Well I got every switch rewired correctly, except the starboard ignition switch. There...
  14. muskokamarc

    How to connect Starter?

    Hey guys - My neighbour helped me uninstall my starter over the weekend and I just got it rebuilt. I would like to try to reconnect it on my own, but don't know what the wiring should be like. Can anyone tell me based on this photo what should be connected to each post? Thank you
  15. Robb Watson

    Oven works, not the stove... (1979/80 360 Express Cruiser)

    Hi All. Looking for some advice as to how to troubleshoot a non-functioning stovetop. It's in our 1979/80 360 Express Cruiser. The oven works find but the stove top does absolutely nothing when I turn on any of the burners. The way the stove/oven is installed, I have no idea of where to begin...
  16. Deep in Depth

    Cockpit Volt Gauges Reversed

    I know this sounds simple to fix but I want to do it right. 2000 Searay 410 Sundancer 3116T Cats I am the second owner and have had this boat for 9 years. I was troubleshooting housebank poor performance or I may not have noticed this. When I start my left engine, the left batteries...
  17. L

    Dash Chartplotter Installation on 1996 Sea Ray 330

    Hello, new to owning a Sea Ray and just bought a '96 330 Sundancer from the Ozarks to its new home in Lake Michigan... Lots to go over on the boat to ensure all is well. One thing I want to do this winter is install a dash mounted chartplotter and am fortunate enough not to have any previously...
  18. B

    wiring diagram dash

    I need a wiring diagram for the dash of a 1994 Signature 185 Bow Rider. Gauges work fine until about 15 minutes of engine run then horn, lights, bilge and blower switches do not work. Want to rewire dash. It was someone's idea of a rats nest in there.
  19. yobub

    Had to cut radar cable...

    In order to transport my boat, I had to cut the cable between the radar array and the display. Long story. The array is a Raymarine 92655 open array which has a flat, 8 lead connector with very small gauge (24?) wire, connecting to a C120 display, and the wire is cut about an inch from the...
  20. J

    Loose wires and non working lights

    I have a 1993 Sundancer 290. I found a black wire and an orange wire with green stripe behind the electric panel that are not connected to anything at on end. Anyone know where they're supposed to go? Also the two lights that are in the forward berth, that are mounted on the front wall next...
Back
Top