trim tab

  1. R

    SPX190 ob - lenco tabs mounting

    Hi! Putting some lenco tabs on my spx190 ob. Obviously not a simple install on these....... so... going to have to put the actuator upper on the horizontal urface under the swim platform. To keep the hinges in line its going to need a 19deg wedge as far as i can tell. Only lenco wedges i can...
  2. R

    TRIM TABS NOT WORKING 2013 540 SUNDANCER

    Hi I am fairly new to Boat Ownership, I have a 540 Sundancer 2013 and the Trim Tabs are not working. I have been trying to locate the HPU but I cannot locate it anywhere. I also pulled the switch from the Control panel but it is a singular wire that I cannot find past where it can be seen. I...
  3. R

    Trim tab and Outdrive trim sensors

    BG: My/Our first boat is a 240 Sundancer. This is our first season at a Marina in a wetslip on the Ohio River North of Pittsburgh. On the dash the gauge for Outdrive trim does not sweep smoothly. When lowering it the needle is at Max Up then as I lower it the needle does not move. As I continue...
  4. S

    2004 340 Sundancer Trim tabs - not working

    So I searched to see if this was already on here somewhere and I couldn’t find it. That probably is more due to being a novice at navigating this forum and less to do with it not actually being posted here. Anyway, I have an 04’ 340 dancer and today my starboard side trim tab just stopped...
  5. D

    400 Sundancer Trim Tabs

    I have a 1997 400 Sundancer and I need to replace a broken trim tab. Does anybody know what manufacturer and model of trim tab I need to buy? I need to replace everything attached to the outside of the boat, including the hydraulic arm. Thanks.
  6. icsdoug

    Zeus Trim Tab Actuator Connector Failure

    Was heading out for the long weekend, (of course), soon as I engaged the stick, had severe shudder/vibration and shutdown immediately. Luckily, we were close enough to the dock to reach some lines. Discovered the port trim tab actuator had broken at the trim tab connection, dropping the trim...
  7. Gunn

    Stumped on trim tab electrical issue

    I have been troubleshooting my trim tab issues and have now figured out a problem...but have no idea how to fix it. Any thoughts or help would be appreciated! I completely disconnected the Bennett trim tab motor/pump. In the ER behind the port engine, I have 5 wires...black (ground) and four to...
Back
Top