transmission

Hi guys need a zf 63Iv gearbox anyone have or no of where I can buy a second hand or new transmission from thanks

My shifters stopped going into reverse. I can reverse connections at the transmission and it goes into reverse. Once side was fixed by messing with corroded shifter switch control made by Zippy. Where can I find a replacement part or identify the part number for certain. Thank you. I think this...

Mercruiser Bell Housing Cover V8. Used mercruiser (GM) v8 bell housing cover with top or bottom mount starter locations. Like new. $170

Posted last month in the Cadillac forum: 1. Going to tow my 4500 pound boat & trailer over the mountains this weekend with my 2017 XT5 with 35,000 miles on the odometer. A factory hitch: surge brakes on trailer's four wheels; modified the Torque App to monitor transmission fluid temperature...

Hi All, It's just getting boating season here, and when I took my new-to-me boat out the other day I noticed it seemed to have difficulty getting into forward gear after backing out of my slot. It seemed to make some grinding noise/chatter/vibration while changing gears, which seemed normal, but...

Afternoon CSR, I am going to use the word...winterization. I am preparing and want to change my transmission fluid. I have a v drive model number 20-02-003. Does anyone have a manual for this. Trying to find how much fluid it takes. Check on the site and can find it for other trannies...

I have procured a pair of drop in replacement motors for my 370 Sundancer that has 5000 V drive transmissions. What I would like to do, is disconnect the engines from the transmissions in the boat, slide the engines forward enough to disengage the drive shafts, and lift them out without...

Hi, Quick question. My old transmission on my 1989 Merc 454 I think is low on oil but I just need to know when I put the dipstick in should I screw it all the way in and than measure it or just put it in and pull it out without threading it in. And also do you have a recommended oil to use in...

I have a 1994 500 Sundancer and after I take it out and get it warmed up the starboard transmission does not seem to engage properly. After running it for a little while if I want to go in a straight line I have to steer the rudders to starboard. When I come back into the Marina to dock (stern...

This is the second time the transmission on my 2001 410DA has overheated to the point that the dipstick has melted. The first time was when it had only 10 hours on the boat in it's first year of operation. I only have about 500 hours on the boat now. Is there any PM that I can do on the...

I recently picked up a Pachanga 27. The boat has been in fresh water most of its life (Naples ME). I am using her on the Long Island Sound (salt water). When I put her in on Friday I ran her for about 3 hours, and she ran great. Other than a loose solenoid wire, which prevented her from...

Hi all. I am repowering my 1989 SR Weekender 300 that has 7.4L MErcruiser straight inboards,330hp I think. I am buying used (rebuilt) drop-in engines, most likely Crusader 454's. However, some I have looked at come as both engine and tranny/drive together. Unfortunately, I can't find the tag on...

borg warner velvet transmission bearings/gears checking if cause shaft vibration This is a continution of my search for shaft vibration on searay 420ac , see that thread. How can the output bearings/gears on the borg warner velvet transmission be checked without pulling transmission. Not sure...

Just purchased this boat during the off season. (already sunk $1000's into it) I have a problem with the Hurth Transmission Control Box leaking oil. Replacement prices are WAY too expensive. Does anyone have of or had experience with replacing or rebuilding these things. Its shoen in this...

Can anyone tell me how to stop the grinding sound when shifting into reverse on an Alpha 1 outdrive? It also feels like the reverse is not engaging unless I push the shifter down a little farther, could this just be an adjustment in my shifting cables? This only happens on the Port outdrive, the...

I am trying to remove the transmission and v-drive from my 89 340 SD with twin 454's space is limited, anyway, I have the engine blocker up and all bolts removed and I assume the unit needs to come out as one instead of Tranny and V-drive separate? So with only about 1.5 inches from v-drive to...

Just purchased a 2006 185 Sport. Took it out for first time yesterday. Running at low rpm there is a noise that sounds like the trim motor running. Apply a little throttle and it goes away. I have read it could be flex plate rattling in transmission, bad U joint, I have no idea where to go...

I have twin 4.3 mercruisers, yesterday i was at apporximately 3000 rpm and the starboard engine tranny seamed to slip, when I brought the rpms down a little I felt it engage again. Could this be checked while in the water? I cannot trailer it. Could it be something simple? can I still use it...