hello,
I got a 2011 185 Sport with approximately 180 hours on it. I just bought it this spring. I want to keep up on maintenance. Is there any way to tell if the risers need to be replaced? Engine temp is fine and I don't have any issues, but I would like to avoid them if possible. Is there...
Hello All,
I am looking at purchasing a 2005 260 Sundancer. It’s has 300 hours on the Mercruiser 350 MPI Horizon motor and has been used in salt water, fresh water and stored on a trailer.
Boat is in good condition overall.
When I purchase I am going to remove and inspect the exhaust risers...
running take out , but 2 freeze plugs missing , still has compression though, i think it just needs a new block, engine is complete, 278hrs on mercruiser reman, bought the boat with this motor , also outdrive comes with it complete engine package, risers are 2 year old , would be a great motor...
Hello, looking to purchase a 2000 SR 270 Dancer with 7.4L MPI.
There are no accurate records of when the last time the risers / manifolds were replaced.
The boat is in fresh water and has 397 hours.
I noticed some rust on the gasket where the riser and manifold meet. Is there any way to...
Like everyone here, I have to encounter the issue of replacement of the manifold and risers. Yet, I am at a loss to determine if the after market stainless is worth it?
http://www.hitekmarine.com.au/products.htm seems to make great claims.
What I want to know for those who are in a salt water...
I bought a 1997 370 and the engines were disassembled and the parts were mostly gone. I rebuilt what I could and sourced the rest elsewhere.
After about 1 hour of running, the Starboard engine back fired, broke the muffler and the heads were popping. Upon removal of the heads, we had water in...
I rec'vd two Merc elbows that shipped with gaskets for twin 4.3/LX engines. The gaskets had two slots that were cut out right where the coolant (closed system) is chambered. I attached the elbows and when filling with new coolant, I realized that I had more than 7 gallons added to a six cylinder...
OK, need any of you 290DA owners to tell me how hard it is to inspect / replace manifolds and risers on the twin 5.0's. I can barely reach the plugs on the port engine due to interference with the water tank and have a VERY :wow: cramped engine compartment overall.
I need to pull the risers...
Im a new dealer for Hi-Tek products of Australia.We manufacture 56 different makes and models of boat Manifolds.We also have hard to find Manifolds.Hi-Tek has the best Warranty on the market. 5 year Warranty.Enough about that. I live on the Oregon Coast.I can see the Pacific from my house.Im a 5...