Anyone replace their dash back-lighting? that works off the dimmer? I did not see a replacement part on the Sea Ray parts sites so I figure this would be a 'try and see' moment with something purchased off Amazon.
Plenty of strip lights out there but the light needs to face inward and a lot...
2 gauges were installed on the starboard side of the dash. One is 2" diameter while the other is 2 & 1/16th". Holes were drilled with the type of hole saws used to install door locks or deadbolts. Appearance is good despite the curved surface. This was a good spot as you can access the back...
Hello All,
I ran into a no power connection on dash gauges for my 2007 240 Dancer 5.0 MPI Bravo III.
I was out on the lake all day the weekend before, got back to the slip without an issue. The following Saturday I went to start up and was not receiving power to the smart craft or any dash...
I just bought a 1987 268 Sundancer. that needed the whole dash to be redone. The gauges and wires are fine but none of the wiring is hooked up. Where can I find a diagram for this? I could probably guess at a lot of it but would hate to have it blaze up on the water. We have a real short season...
Hi, We have a new to us used SeaRay 260 all the dash gauges from RMP, trim to Fuel are now in constant motion up and down - does anyone know how to re-set these, or get them off the test mode, if that is what it is? Thanks, Frank & Alma
UPDATE: While in the San Diego Bay, a water cooling...