Hi guys, I recently purchased a 95 330 v-drives 7.4 carbs. I have to pull it out of the water and replace the starboard shaft. I have never done this job before but I have done just about everything else on them. Any help on actually removing the shaft from the flange would be greatly appreciated.
So here is the boat.
1984 270DA
Single 330 mer.
Dual Fuel tank
Appears to be Original Carburetor History unknown (mer 1347-8291)
19.75 x 19 prop (Fresh rebuild)
Here is my problem:
Cannot get boat to plane out, @ WOT underway I am only getting at the most 3200 RPM and what seems to be a rich...
Hi all, I have a new used 1997 Sundancer 330. So I went to the boat and no juice. The battery indicator on the control panel indicates port battery is dead. No juice to hatch lift or blower. No juice to start engine. I use the emergency start to access the starboard battery and start engine...
Hello, new to owning a Sea Ray and just bought a '96 330 Sundancer from the Ozarks to its new home in Lake Michigan... Lots to go over on the boat to ensure all is well. One thing I want to do this winter is install a dash mounted chartplotter and am fortunate enough not to have any previously...
Bought the boat in 2014 and only ran it during sea trial and winterizing. When we bought the boat I knew there was a problem with the port motor and ended up rebuilding it. During the sea trial and winterizing I seem to remember the starboard motor running very smooth with no issues (of course...
Now that my fuel lines are all 19 years old I think its time to change them. Im going to buy the fuel line in bulk length and have a local line/fitting shop install all the threaded ends.
Considering there are so many connection points I will to do one side at a time so I don't confuse how they...
I recently bought a 1994 Sea Ray 330 with I/O and I desperately need a swim platform. I really do not care what shape it is in, as I have a good fiberglass guy that can fix it(if it is fiberglass). I am fine with one that has been used and taken off, or a new one if it is a reasonable price...
I guess its too late to ask, but does anyone have experience with Aquaguard water based ablative bottom paint? I did my 330 today (painfull process with snow and ice between the boats, see pics). Seemed to go on well but it was a cool day at about 55 degrees. I had heard it dries fast which can...
hi everyone,
We just bought a 1997 Sundancer 330 and wanted to say hello to this group. I have been on this site in the past although I never registered or posted.
My name is Steve and I am up in NY.... although my boat is still in Maryland. Yes I am counting the hours until I can drive it...
I have a 1996 330 DA with a Norcold DE-541 fridge that the compressor is shot. Has anyone had experience with replacing the fridge with a new one vs. repairing the existing one? I have read in other posts that getting the new fridge in through the hatch is the big issue here. Some posts seem to...