Does anyone know the OEM for the head faucet/shower fixture for my boat? I believe it might be a Grohe Marine Faucet model 31547. Also , does anyone know the OEM for the toilet paper holder. Is it attached with adhesive? Both have deteriorated and need to be replaced... Thanks!
The hatch is not closing properly. The latches appear to be ok, but the port latch does not catch when closing. The hatch,when closed, is out of alignment. Anybody got an idea of what to do?
Recently had to have the transom shield replaced on my 260 DA. Now the helm center is off. The shop told me that there is nothing that can be done to adjust it. I find this hard to believe. What can be done?
Just notified by my mechanic that the engine on my 2004 260SD has to be pulled to fix a water leak at the throttle thru hull location. Any advice on what should be done while the engine is out?
Thanks!
My gen set will not start and I am having trouble getting service. It turns but will not catch. I noticed that there is a loose wire with a white connector on the end hanging near the black control box. Can anybody tell me where this connects?
When draining my bilge this weekend I notice something attached to the inside of the drain hole. It appears to be attached and is larger than the drain hole. I'm concerned it is blocking the drain. Any info on what this is?
During a recent service call the mechanic stepped on the forward mouting board in the bilge that holds various plumbing parts. He has since come back and repaired the damage. It still appears to me that its not right, but I dont have a picture of what it looked like before the incident. Does...
I have a couple of small uphostery abrasion holes (less than 1/4") in my 2004 260 SD seats. I wanted to catch them early. Has anyone had any successful experience with vinyl repair kits?
I recently purchased a 2004 260 DA. The boat had been bottom painted and so is the outdrive. I have wear spots on the outdrive revealing the original shiny black mercruiser paint. Any suggestions on how to remove the bottom paint and retain the mercrusier black?
Thanks
Does anyone have any tricks of the trade for manuevering and working in the small bilge area of my 260. I have a 350 Mag with a generator... and I dont know how to position myself to do simple maintenance and cleaning... No where to put my feet or sit where I can get at anything. I thought...