Search results

Romp's in Vermilion, OH on Monday, 5/25 $2.53, 89 Octane, no ethanol

Tony, I would be interested in the vent covers. What cost are you looking to manufacture?

Yikes! The beer was warm! Looks like the cockpit refrigerator bit the dust during the week. Anybody replaced this little fridge? Looking for good options/best cost. Probably could mess around with repairs, but I figure after 12 seasons it deserves to retire. I know these units are...

Tony, If you mean the plastic trim pieces on each side of the stern that are intake and exhaust blower vents for the engine compartment, they are no longer available through Sea Ray - they are discontinued after 10 years. I also tried the manufacturer (forget who it was) to see if the molds or...

Scott Cambra Vector Imaging (508) 730-2954 www.vectorled.com scott.cam@verizon.net scott.cambra@vectorled.com 153 Barnes St Fall River Ma, 02723 This is the guy who makes the panels for Flounder Pounder. Scott is great to work with. If he has the pattern for your boat he can make them...

http://www.middlebass2.org/pictures_recent.shtml Here's the link to the Middle Bass Island web site with a list of the new marina photos showing contruction through the process. Last few show the new marina with water - iced over! Docks going in this spring.

I had the same boat, similar problem, but perhaps not leaking as badly. Turned out to be the deck-to-hull shoebox joint under the rub-rail, but in the same general area as your leak. In places, the shoebox joint is wider than others due to mold imperfections and is only filled with caulking...

1997 330sd subwoofer The subwoofer was an option. It was installed on the lower panel next to the helm seat.

Vandals have struck Bruzer Where in Vermilion are you stored? I'm there too - Romps. There has been trouble with breakins and vandals all summer. A 30 Weekender like yours had both carbs lifted during the week this summer. Romps has 24 hour cameras but they didn't catch it.

Modifying the isenglass on camper canvas Have a canvas shop make up a new center section as a screen. As long as it isn't raining or you're running in bad weather, the screen works great for bugless ventilation. Change to the regular isenglass center when needed.

http://prd.triumphboats.com/ Take a look at this video, and the entire site for Triumph boats. The video will make your day!

I have the same boat, same problem. Here is the answer from Al Holt - expensive.