Here is the background. Over the last couple of years, I have switched all my nav lights to LED nav lights. Not just the bulb. Each unit is specifically designed for this. If I recall, they are all Attwood units.
When I had just the bow lights and the "mast" lights as LEDs, everything was...
I have a '99 310. When starting the port engine, the alarm is barely audible. When the engine starts, everything is normal and the alarm, however faint, stops because everything is normal for engine operations.
I am thinking the horn is failing. Has anyone else encountered this? Is it a...
I have a '99 310 with v-drives and twin 5.7 with carbs.
The volt meter on the port engine reads low. It shows 12-12.5, yet when you check the volts coming off the alternator itself, it shows 14.5 and the engines always start.
This side is for the starting battery. I replaced the gauge...
'99 310 Sundancer
The pump cycles on every few minutes and after a while, the carpet at the base of the steps is damp. Eventually the carpet in the cubby under the stairs is damp and the carpet adjacent to it. The wet carpet only occurs when the pump is on and there is not a lot of water...
We have a '99 310 sundancer and the current way we are securing two kayaks to the bow when we go on extended cruises is with bungee cords to the rail.
I have done a search and have not found much. Anyone have a better way?
Thanks,
Patrick
I need to change my cutlass bearings out and was curious if anyone has used this yard? I ask because they offer a BoatUS discount of 10% on haul out and parts.