Hey Jeremy… i see that you posted a few years ago looking for bilge paint to match the Sea Ray Oyster color. Did you find a source that matched the color that you can share with me? Thank you.
Hello -
I have a significant water leak around the swim platform rub rail. From inside the engine room there is a steady stream of water coming in from four of five areas that look like screw holes. The leak only happens when the boat is underway at speed, and not while sitting in the slip or at...
I've been working on the boat to get her ready for the season before she is launched in the next few weeks. When I plug it in directly to shore power to charge the batteries and run the lights and stereo, I can hear a loud humming noise on the Starboard side of the boat. Upon inspection I have...
I have a 1999 380 Sundancer. The engine vents do not have a screen, and the birds are making themselves a home. Does anyone know if Searay makes vent screens, or has anybody manufactured any?
Used Weaver Davit system - $150 plus shipping. Only what is shown in the picture. The rubber pads for the dighy and mounting screws to the swimplatform not included.
Marinco Single 50A Male to 30A Female cord - $75 plus shipping or pickup.
Marinco Single 30A Female to 15A/110V Male cord - $60 plus shipping or pickup ( 2 available )
I have pictures available.
Dan,
I have the rings with the swim platform davits. Unfortunately, I couldn't get the pads off the dinghy. If you're interested, I'm looking to sell both for $150.
Thx,
Gus
I'm looking to purchase an RL80C Plus to combine my radar and GPS into one unit. I currently have two units which makes the dashboard look cluttered.
Please contact me if you have an RL80C Plus for sale in good working condition.
Thanks,
Gus
I’m buying a used 1999 Sea Ray with 7.4L EFI motors and I also want to switch to a synthetic motor oil other than a Mercruiser product. I’m leaning towards the AMSOIL Synthetic 15W40 Diesel and Marine oil. Anybody else have any recommendations?
Thanks Chuck! My carbs are brand new, but I guess it's conceivable that there could be an internal problem from the factory. I'm waiting to hear from the marina to see if there is a warranty still left on these carbs ( I had them installed end of May last year ).
@magster65 - I calculated the difference over the last 4 fill-ups by simply calculating time run and gallons used. I don't have fuel flow meters, but have switched tanks to see if if it was fuel tank related. Engine runs fine, although when cold it sometime stalls and runs rough ( something both...
Last May I had 2 new carburators installed with tune-ups ( plugs, caps, rotors and wires ). I also replaced the ignition modules and coils on the motors ( paid the marina dearly - over $4K ). My problem is that my Starboard motor consumes roughly 5 gallons of fuel per hour more than my port...
I have a 97 Dancer 330 with 454 V-Drives, carbs, RWC engines. I sent both carb out to be rebuit by a professional company. I installed carbs and..
Starboard - motor idles fine and seems to run fine at cruising speed, but 10 -15 minutes of cruising the motor starts to lose power and shuts down...