I had to replace both shafts on my 2006 40 sea ray with QSB 380's two years ago. There was no impact in fact the prop fell off when the boat was put into gear. The port side shaft broke at the prop and when the starboard side was examined it had the same metal discoloration on the shaft at...
My port side shaft broke this weekend right after the strut. I was cruising along with no vibration and I pulled into a cove to pick up my mooring. Once my wife grabbed the pickup stick I touch both engines in reverse to back off the mooring. I shut the boat down and relaxed a few hours. I...
Mackrel Cove is better protected then Bonnet Shores. If you have a southeast wind then it can get rough in Mackrel Cove. It is deep in there and you can get close to the shore. I have never gone to the beach in there, but have anchored quite a bit there. Hope this helps.
Have you ordered the bracket? If so, do you have a part #. I have the steering sensor, but I need the bracket. The bracket I have is for I/O. Who did you call to get this picture sent to you. I called two dealers and neither one called me back.
I too have inquired on this. I have 2003 320 with inboard 6.2's. I called mercury smartcraft and they said that they do not make a bracket to mount the steerig sensor on inboards and that I have to call Sea Ray to see how they mount it. I placed a call into a dealer yesterday and I am...
How did you mount the bracket? The instructions say to mount it to the transom plate. I have 2003 320 with 6.2 v-drives that doesn't have the transom plate. Where did you mount yours?