Search results

  1. P

    Sundancer 300 Control Panel Question

    Excellent - thanks very much!
  2. P

    Bilge Heater for Sundancer 300

    The boat came with an additional BoatSafe 700W and based on your responses, my guess is that it was likely used to supplement the Xtreme. The issue for me is that the BoatSafe has to be plugged in (of course) whereas the Xtreme has been hard-wired into the boat AC circuit. To plug in the...
  3. P

    Bilge Heater for Sundancer 300

    No experience to offer. This is the first cruiser we have had. Sorry.
  4. P

    Sundancer 300 Control Panel Question

    On this boat (new to us), I have found a couple of buttons on the control panels that I still can't figure out. One is labelled "Comp" and is located on the section for lighting. A photo of the other is attached. It has a figure of something like a heater (?) above the the "Acc 2" button but...
  5. P

    Bilge Heater for Sundancer 300

    We recently acquired a Sundancer 300 and we're still learning the boat. Since we're now approaching winter weather here in East Tennessee, we are wanting to be sure that the bilge heater in the boat will be adequate. We assume this will be the case since the boat is from this area and the...
  6. P

    2007 Sea Ray 300 Sundancer

    Big help - thank you. I'll check the batteries. I have the boat getting the bottom repainted right now but should have it back in a week or so. We love the boat and can't wait to really spend some time in it. and I'm rally glad to hear your report on outdrive trim. I noticed when I pulled...
  7. P

    2007 Sea Ray 300 Sundancer

    Hello. New to this Forum and to this boat. It has the two Mercruiser 5.0 engines with the Bravo III outdrives. I have noticed that the boat has a slight list to the port side (just sitting still in the water) and I'm not sure why this might be. It has fuel tanks on each side, the generator...
  8. P

    Sea Ray 300 Buyer Advice

    Thanks. Freshwater.
  9. P

    Sea Ray 300 Buyer Advice

    We are looking seriously at a 2007 300 Cruiser with the twin Mercruiser 5.0's and Bravo III's, and would appreciate any advice that might be offered about this year and model. I am particularly interested in any known areas of weakness or specific things to be aware of such as manufacturing...
Back
Top