I just lost the sale of our boat for boarderline oil results. I tried to upload the pdf file but too big. Can someone here give me the facts of our report, so I know if I have a real issue or not.
We did the test twice, once, then changed the oil, ran the motors, retested. I don't have the...
We are getting black specks, sort of look like mold on the back and top of the rear seats of our 2006 300 Dancer. Tried vinyl cleaner and clorox cleanup, but still there. Any ideas on how to clean this up?
On occasion I loose comm connection between the Smartcraft and the Starboard engine. I go down in the ER and wiggle some wires, then restart and it comes back. Don't really don't know which wire is faulty or loose. Anyone have any experience with this issue?
I replaced the manifolds today, and noticed the ball inside this valve was stuck. I freed it up and cleaned it. Put it back together.
Does this cause overheating?
What is this valve called?
What is its function?
It is 8, 9, 10, and 11 on the attached link...
Can anybody tell me how to read an alarm? I was on my way back from a boating weekend and check engine went off. Everything seems normal. All the gauges seem fine, checked motor, all fine. Went below to get the Smartcraft Operation Manual and says check the Operator, Maintence Manual. The gauge...
I guess I didn't do a very good job painting my outdrives last year. It barely lasted. What is the best outdrive/bottom paint to use on my 2006 BIII Outdrives?
Does anyone know what this switch is for? It is the squigly one, on the starboard side, above the ACC2 button. I can hear the relay clicking, but no idea what it is for.
2006 300 Sundancer
Who is going to watch the boat races this weekend? And where do you watch from? I've gone a few times by boat, but it has always been a hastle. My wife was persistant to go by boat last year, 1st time for her by boat. I told her it was going to be no fun, but we went anyway. I spent more time...
How exactly are these supposed to work? And what is the life expectancy? We tore our motor apart, and found no cracks what so ever. The mechanic said our Flappers were fine. For approx $50.00 each, I think now is the time to replace them.
See other thread on this subject...
Coming back from a 3 day weekend trip, Docked, cleaned the boat, started each motor to run flush through them. Starboard motor failed to turn. Fried the starter in the process. Next day, found a little water in the plug holes, but may have been from not draining all the water from the manifold...
I have a 2006 300 Sundancer. I was told there is a crossover between the tanks. I can not visually see that in the boat or in the parts list. Can someone tell me how the fuel system works?
I dropped my NS100 VHF, and the clear lens landed right on a snap! Go figure? The unit is still good, but has a crack across the display. I am in search of a dead unit I can swap the outer shell on. Has anyone upgraded or replaced their NS100 that I could get their old unit cheap? I would like...
I have a 2006 300 w/ 5.0 BIII
The Port throttle lever slack is looser than the Starboard. There is nothing loose on the engine. It seems it is loose in the controls. Also, is the detent adjustable? I don't feel any, and is difficult to feel Forward and Reverse.
What brand and model do I have?
I have a 2006 300 w/ 5.0 BIII
I have a little slop that I believe is excessive. I had the Admiral turn the wheel, slop to slop, while I was watching the cylinder behind the engines. The shaft going through the cylinder was loose, approx 1/2" left to right. Is there an adjustment to remove this...
I recently purchased a 2006 300 Sundancer with a norstar 6000i gps/plotter. It is missing the chip. I need a chip for the western Florida area. Andbody have a used one laying around they no longer need? It is the CF size.