Search results

The marina I go to had a bucket of pump out fittings, and someone stole it a couple weeks ago. I was looking for what size to order to have one on my boat. I had no luck finding any real info online for my 1993 270DA. I found this one on Amazon and it it fits my 270 and my marina neighbor's...

Ok. Here's the update. I was having trouble pulling the old cable out because of the nut on the end of the cable. I had it 2/3 out when it got stuck. I found the mark that said it was the 19.5ft cable, so I ordered the 20ft. I ended up cutting the old cable just above the deck in the little...

I am going there today to check that. I don't think it's anything in the stern end because the gimbal and outdrive were all replaced in Sept, 2021. I was looking through my paperwork and found the SeaRay replacement parts list and it shows two different steering cables for my boat one is 18.5ft...

I was the first one in the water this year and then I couldn't steer. It was a pain getting to its slip from the ramp lol and thank you for your help. It's not easy finding info on these older SeaRays

Oh and it's not stock either. The previous owner had a 496mag installed with a fresh water cooling system and the mercruiser smartcraft stuff

Actually thinking about it my friend a few slips down flushed the power steering for me last season because the steering was getting stiff. I was thinking of doing the rack and pinion because I seen one that cones with the cable and is about the same price as the cable itself.

Yes I believe it has power steering but not entirely sure. I'm thinking about just replacing the helm unit and cable since the boat is 20 years old.

HI Dave. I have a 93 270DA and last season I noticed it was getting hard to steer and I had a lot of play in the wheel. This year when I launched I was barley able to get to my slip because it was so difficult to turn. Since I got it to the slip the wheel will only turn till it runs out of play...

So the mechanic has been looking for an hour and can't pin point the leak. He said he doesn't think it's the tank though so that's good. It looks like it would be a nightmare to have to remove

I checked all the lines and top of the tank where the fill and vent are and where the sending unit is and where the motor sucks the fuel out. I also put tracer dye in the tank and the only place I can see it coming from is under the tank. I put a work order in at my marina to have there...

I noticed a fuel smell in my boat last weekend and found fuel in the bilge. I noticed the fuel was coming from under the tank. I removed the wood under the cushions in the mid cabin and seen fuel down between the tank and compartment the tank is in. My question is if the motor has to be removed...

It didn't post them all lol

That doesn't sound very good. I just purchased my first boat a week ago. It's a 93 sundancer 270. I had it surveyed for moisture. And the previous owner had it recovered 2 years ago. It currently has 140hrs on the new 496mag.

Hello Kevin what is bravoittis lol