Search results

Ours was replaced on our 2003 390 MY in 2017 with a Splendide 210 XC. Drop in replacement.

Be sure your boat yard is aware during lifts as they hang down below the hull. Be sure the outlets are clear of the straps on the travel lift. Our 2003 39 MY has warning decals along the exterior of the gunnels to address this.

Recaulking salon and v-berth bow windows 2003 390MY I finally got to this project. I thought I'd share what I did. I'm sure some of you will need to have this done at some time. I think it turned out good. I used the Sika products: 295UV sealant, Activator 205 and Primer 205 G+P. Here's my...

No, unfortunately not.

SKybolt. The Smartcraft and RL80 are already connected via a network (assume NMEA 0183) thru the Sea Ray Navigator (SRN). It appears the power for the xdcr is from the SRN. When the SRN is on, I can see depth across each display, when SRN is off, they are blank. Seems like if I can get power to...

SKybolt, thank you for the details. Attached are 2 pics of the current buss. Also a pic of the dash. I have a Raymarine RL80C Plus for a chartplotter, which is connected to ST7001+ Autopilot and Raymarine open array radar.

Ttmott, any chance you have info and specifics on how to wire the xdcr from the SRN and connect to the Ray NMEA0183 network. The xdcr is a multi pin connector (computer style). I have located a buss for the 0183, just not sure how to wire it in correctly.

We have a 2003 390 MY with the Navigator (SRN) and RL80C. I've read this forums content on the SRN and realize the shortcomings of the SRN and hope to replace with a newer chartplotter in the near future. I've been chasing an alarm that is isolated to the SRN. I have once seen an alarm code...

I'm curious if other 390/40MY have this (circled in the attached photo) in the engine room bilge sump. Is it a mid-ship drain?

Cockpit sink slow draining The small sink in the cockpit of our 2003 390MY drains slowly. I found that it doesn't drain out the starboard side thru hull as the manual implies, but rather to the sump in the ER. The cockpit AC drain hose tees into the sink drain hose in the ER just above the AC...

I have a 2003 Sea Ray 390 MY with the Maptech Sea Ray Navigator. I noticed on the back of the monitor there is a VGA 15-pin port and a S-video socket. Would either of these support a video camera? I'm thinking of installing a camera on the stern of the boat to keep on eye on the dinghy while...

I have a similar random alarm inside the dash on our 2003 390 MY with 480C Cummins. Systems Monitor shows "All Systems OK". Analog gauges for oil pressure and temp show good operating levels. Ours has the Sea Ray Navigator and I'm convinced it is triggering the random alarm. We were cruising...

Try this thread: http://www.clubsearay.com/index.php?threads/410-sundancer-express-cruiser-and-400-sundancer-express-cruiser-official-thread.53469/

I received a response from Vetus on this: The prop has been changed to a 6 blade prop. Part number is SET0088 Anode is SET0150 Shear pin BP228S Brushes SET0056

Vetus Thruster 80KGF 24VDC 7.28"ID TUNNEL (aka 185mm dia) I'm trying to solve a mystery relating to the bow thruster. I was going to order a new anode and the maintenance manual shows a 6-blade propeller. Ours is a 3-bladed impeller. I'm away from the boat to really inspect this, but is it...

Repitched props, now 24 x 26, are re-installed. I'll plot the GPH/RPM/Speed in May when we splash.

Anyone have a Weaver Davit system on their 390/40 MY? We just got a new to us dinghy with the Weaver parts and motor mount system. I need to reposition davits to the swim platform and am curious about access inside the swim platform for bolting. I am planning to use the blind fastener system...

I am having the same discussion with Air Marine. I am taking our 24 x 27 props to 24 x 26 and reducing cup.

Thank you DanH951. Mine closely follows the Cummins 480 CE spec and I'm reducing the prop pitch to reduce the GPH. Curious what changes you did to the boat between Spring 2022 and Sep 2022. Did you re-pitch and if so what prop pitch did you have for both instances?

Yes , I have this info for the engines. I'm looking for info specific to the 390/40 MY performance