Search results

Scrumper got a good point

It's definitely leaking some where. But like others said any hydrolic shop can make it ,but could be the value,have it looked at if need be

Flip up bolster seats work great on sea rays

What's a cracking,you mean cranking i hope, I have 1 cranking and 1 deep cycle for house. Never had a problem

Also look at harmonic balancer ,make sure it's on tdc

Just put your wires from the rotor pointing towards the number one cylinder start with one and go 18436572 You should be fine

If you use a good charger it will actually tell you what's wrong with it if it's good it'll charge it in a way that protects the batteries they're expensive they're like a smart charger I bought one and I have 5 years on my batteries and they are tip top

I use a 17 pitch prop. Holeshot is great and still have a great top end

Run it on the muffs. My boat is so quiet on muff it sounds like it's in the water. Spend 10 min. My oil drain is on my drain plug it works fine

What?

TaylorMade covers should work

It's worth it

Then there is a problem no. What good is clean oil if it can't run??

Why not just warm it up on the muffs. 5 min

Sig has some nice 9mil and 380 guns . Brother in law has them and the are so easy to grip and shoot. I'm fine with sig 365 9 mil nice small powerful

Below the casting. Picture please mine comes out of the transome exhaust amd spots a little water out the prop I think

Where did you end up installing your transducer I'm just curious

You guys get crab pots down that way, we get lobster traps all over the place it's like driving through a minefield up here around the cape it's like everybody and their brother has a 10 trap license

Take the day off lol

So it wasn't the flux capacitor then damn